Related Questions

When screw threads are to be used in a situation where power is being transmitted in one direction only, then the screw threads suitable for this will be
A Knuckle threads
B Square threads
C Acme threads
D Buttress threads
While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as
A both ends fixed
B both ends hinged
C one end fixed and other end hinged
D one end fixed and other end free.
A lead-screw with half nuts in a lathe, free to rotate in both directions has
A V-threads
B Whitworth threads
C Buttress threads
D Acme threads
The lead screw of a lathe with nut forms a
A sliding pair
B rolling pair
C screw pair
D turning pair
In a center lathe, the cutting tool is fed in _________ with reference to the lathe axis.
A Cross direction only
B Longitudinal direction only
C Both cross and longitudinal direction
D Any direction
If threads on a bolt are left hand, threads on nut will be
A Right hand with same pitch
B Left hand with same pitch
C Could be left or right hand
D Right hand with fine pitch
For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately
A 0.4 times
B 0.6 times
C 0.7 times
D 0.8 times
A feed gear box for a screw cutting lathe is designed on the basis of
A Geometric progression
B Arithmetic progression
C Harmonic progression
D None of these
When the nature of contact between the elements of a pair is such that one element can turn about the other by screw threads, the pair is known as a
A Screw pair
B Spherical pair
C Turning pair
D Sliding pair
If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited
A Square
B Acme
C Buttress
D BSW

Next steps