Related Questions

When the back pressure of a nozzle is below the designed value of pressure at exit of nozzle, the nozzle is said to be
A Choked
B Under-damping
C Over-damping
D None of these
A jet of water is striking at the centre of a curved vane moving with a uniform velocity in the direction of jet. For the maximum efficiency, the vane velocity is ________ of the jet velocity
A One-half
B One-third
C Two-third
D Three-fourth
The force exerted by a jet of water impinging normally on a plate which due to the impact of jet, moves in the direction of jet with a velocity v is
A $$\frac{{{\text{wa}}\left( {{\text{V}} - {\text{v}}} \right)}}{{2{\text{g}}}}$$
B $$\frac{{{\text{wa}}\left( {{\text{V}} - {\text{v}}} \right)}}{{\text{g}}}$$
C $$\frac{{{\text{wa}}{{\left( {{\text{V}} - {\text{v}}} \right)}^2}}}{{2{\text{g}}}}$$
D $$\frac{{{\text{wa}}{{\left( {{\text{V}} - {\text{v}}} \right)}^2}}}{{\text{g}}}$$
A couple spent $244 in total while dining out and paid this amount using a credit card. The $264 figure included a 20 percent tip which was paid on top of the price of the food which already included a sales tax of 10 percent. what was the actual price of the meal before tax and tip?
A $184
B $204
C $212
D $200
In impulse turbines, when friction is neglected, the relative velocity of steam at outlet tip of the blade is _________ the relative velocity of steam at inlet tip of the blade.
A Equal to
B Less than
C Greater than
D None of these
The abrasive slurry used in ultrasonic machining contains fine particles of
A Aluminium oxide
B Boron carbide
C Silicon carbide
D Any one of these
A nozzle is said to be a divergent nozzle
A When the cross-section of the nozzle increases continuously from entrance to exit
B When the cross-section of the nozzle decreases continuously from entrance to exit
C When the cross-section of the nozzle first decreases from entrance to throat and then increases from its throat to exit
D None of the above
The energy loss in flow through ven-turimeter is less than that through flow nozzle, because in case of a flow nozzle, the
A Length is shorter
B Throat diameter is more
C Sudden expansion of flow in the downstream occurs
D Distance between the throat and the inlet is more
A nozzle is said to be a convergent nozzle
A When the cross-section of the nozzle increases continuously from entrance to exit
B When the cross-section of the nozzle decreases continuously from entrance to exit
C When the cross-section of the nozzle first decreases from entrance to throat and then increases from its throat to exit
D None of the above
The discharge of steam in a convergent-divergent nozzle __________ after the throat (i.e. in the divergent portion of the nozzle)
A Remains constant
B Decreases
C Increases
D None of these

Next steps