Related Questions

Pharmacists recently conducted a study with respect to the reasons their customers purchased eye drops to soothe eye dryness. Dry eyes were more frequently experienced by customers who wore contact lenses than by custorners who did not wear contact lenses. The pharmacists concluded that wearing contact lenses, by itself, can cause contact wearers to have dry eyes.
A An inherited condition can cause both weak eyesight and dry eyes
B Physical exertion causes dry eyes in many people who wear contact lenses.
C Most people who have dry eyes do not wear contact lenses.
D Most people who wear contact lenses do not have dry eyes.
In metal machining, the work-tool contact zone is a zone where heat is generated due to
A Plastic deformation of metal
B Burnishing friction
C Friction between the moving chip and the tool face
D None of the above
The mechanism of material removal in EDM process is
A Erosion and Cavitations
B Cavitations and Evaporation
C Melting and Evaporation
D Melting and Corrosion
Two circular dials of exactly the same size are mounted on a wall side by side in such a way that their perimeters touch at one point. Dial 1, which is on the left , spins clockwise around its center , and dial 2 , which is on the right spins counter clockwise around its center . (Assume that there is no friction at the point of contact between the dials.) Each dial is marked on its perimeter at three points that are at equale distances around the points arked ondial 1 are N, O, and P and the points marked on dial 2 are X, Y, and Z. If points O and Z are just meeting at the point of contact between the dials , and if dial 1 spins at the same speed as dial 2, what is the smallest number of revolutions of each dial that will bring O and Z together again?
A 1
B 2
C 3
D 4
If points P and X are just meeting at the point of contact between the dials , and if dial 2 spins at exactly double the speed of dial 1, which of the following pairs of contact ?
A N and Y
B N and Z
C O and X
D O and Z
If points P and Y are just meeting at the point of contact between the dials , and if dial 1 spins at exactly three time the speed of dial 2, which of the following pairs of points will be the next pair to meet at the point of contact?
A N and X
B N and Z
C O and Y
D P and Z
Mujahid can do a work in 8 days, while has colleagues Asad takes 12 days and Mithun takes 16 days to complete the same.Mujahid and Asad started the work and after few days Asad left the work keeping it incomplete. Rest of the work was completed by Mujahid and Mithun in 2 days.How long it took to complete the whole work?
A 4 days
B 5 days
C 6 days
D 8 days
The rolling contact bearings as compared to sliding contact bearings have
A Low starting and low running friction except at very high speeds
B Accuracy of shaft alignment
C Small overall dimensions
D All of the above
Indirect contact heat exchangers are preferred over direct contact heat exchangers, because
A Heat transfer co-efficient are high
B There is no risk of contamination
C There is no mist formation
D Cost of equipment is lower
Faruk can do a work in 12 days and Salam can do the same work in 8 days. If Faruk , Salam and Babu work together , they can complete the work in 4 days . How many days will it take Babu to complete the work alone ?
A 16
B 20
C 24
D 32

Next steps