The function of a radiator fan in the cooling system is that

A It blows air through the radiator when necessary
B It is turned by wind force as the vehicle moves forward, and its rotation drives the water pump
C It cools the engine by blowing air onto the cylinder block
D It draws heat out of the engine compartment

Correct Answer: It blows air through the radiator when necessary

The Functions of a Radiator Fan It can push air through the radiator core or pull it through. It must cool the antifreeze that circulates through the block and head passages and reduces the engine temperature
Bissoy MCQ
#Mechanical Engineering #Automobile Engineering

Related Questions

Transformers with a capacity of up to _____ have a cooling radiator system with natural cooling
A 2 MVA
B 5 MVA
C 7.5 MVA
D 10 MVA
Noise produced by cooling fans (employed in air cooled heat exchangers or cooling tower) is mainly caused due to the turbulence created by blade passage through air. It can be reduced by use of a slower fan
A With greater number of blades
B Of increased diameter
C Both A & B
D Neither A nor B
The capacity of induced draft fan compared to forced draft fan in a boiler is
A Same
B More
C Less
D Less or more depending on size of boiler
For the same draught produced the power of induced draught fan as compared to forced draught fan is
A less
B more
C same
D not predictable
If a man reduces the selling price of a fan from Tk. 400 to Tk. 380, his loss increases by 2%. The cost price of the fan is:
A Tk.480
B Tk.600
C Tk. 1000
D Tk. 1060
________ cooling is the process of dissipating the armature and field winding losses to a cooling medium circulating within the winding insulation wall
A Direct
B Indirect
C Conventional
D Any of the above
The cooling effect in a cooling tower can not be increased by
A Increasing the air velocity over the wet surfaces
B Reducing the humidity of entering air
C Lowering the barometric pressure
D None of these
Gas cooling as compared to water cooling of nuclear reactors
A Can not attain a high temperature
B Is more efficient as gas has a higher specific heat
C Can produce only saturated steam for feeding to power turbine
D None of these
The ratio of the temperature rise of cooling water to the vacuum temperature minus inlet cooling water temperature is called
A Condenser efficiency
B Vacuum efficiency
C Nozzle efficiency
D Boiler efficiency
In self cooled motors the cooling time constant is about ______ than the heating time constant because cooling conditions are worse at standstill.
A 2 to 3 times greater
B 3 to 4 times greater
C 4 to 5 times greater
D none of the above

Next steps