Related Questions

A _________ in a boiler is used to put off fire in the furnace of the boiler when the level of water in the boiler falls to an unsafe limit.
A Blow off cock
B Fusible plug
C Stop valve
D Safety valve
Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of __________ will facilitate the most accurate measurement of the temperature.
A Copper
B Steel
C Aluminium
D Brass
Minimum thermal efficiency of a steam boiler may be around __________ percent
A 25
B 45
C 65
D 20
Maximum thermal efficiency of boiler may be about __________ percent.
A 10
B 25
C 65
D 90
Thermal efficiency of a thermal power plant is of the order of
A 15%
B 20%
C 30%
D 45%
Thermal conductivity based continuous flue gas analyser makes use of varying thermal conductivity of the constituents of flue gases. Which of the following constituents of flue gases has the maximum thermal conductivity?
A CO2
B N2
C O2
D CO
Which of the following statement indicates the difference between Cornish boiler and Lancashire boiler?
A Cornish boiler is a water tube boiler whereas Lancashire boiler is a fire tube boiler
B Cornish boiler is a fire tube boiler whereas Lancashire boiler is a water tube boiler
C Cornish boiler has one flue tube whereas Lancashire boiler has two flue tubes
D Cornish boiler has two flue tubes whereas Lancashire boiler has one flue tube
For the same diameter and thickness of tube, a water tube boiler has ________ heating surface as compared to fire tube boiler.
A More
B Less
C Equal
D None of these
Steam in water tube boiler as compared to fire tube boiler
A Can be raised rapidly
B Is raised at slower rate
C Is raised at same rate
D Could be raised at fast/slow rate depending on design
A device used to put off fire in the furnace of the boiler when the level of water in the boiler falls to an unsafe limit, is called
A Blow off cock
B Stop valve
C Superheater
D None of these

Next steps