Related Questions

The lowest temperature during the cycle in a vapour compression system occurs after
A Compression
B Expansion
C Condensation
D Evaporation
In vapour compression cycle the condition off refrigerant is dry saturated vapour
A After passing through the condenser
B Before passing through the condenser
C After passing through the expansion or throttle valve
D Before entering the compressor
In vapour compression cycle, the condition of refrigerant is very wet vapour
A After passing through the condenser
B Before passing through the condenser
C After passing through the expansion or throttle valve
D Before entering the compressor
In vapour compression cycle the condition of refrigerant is superheated vapour
A After passing through the condenser
B Before passing through the condenser
C After passing through the expansion or throttle valve
D Before entering the expansion valve
The temperature of ammonia after compression in a vapour compression system is
A 20 to 50°C
B 50 to 70°C
C 70 to 110°C
D None of these
In a vapour compression system, the condition of refrigerant is dry saturated vapour
A Before entering the compressor
B After leaving the compressor
C Before entering the condenser
D After leaving the condenser
In a vapour absorption refrigeration system, the compressor of the vapour compression system is replaced by
A Liquid pump
B Generator
C Absorber and generator
D Absorber, generator and liquid pump
The higher temperature in vapour compression cycle occurs at
A Receiver
B Expansion valve
C Evaporator
D Compressor discharge
Otto cycle efficiency is higher than Diesel cycle efficiency for the same compression ratio and heat input because in Otto cycle
A Heat rejection is lower
B Expansion and compression are isentropic
C Combustion is at constant volume
D Maximum temperature is higher
Lowering of condenser temperature (keeping the evaporator temperature constant) in case of vapour compression refrigeration system results in
A Increased COP
B Same COP
C Decreased COP
D Increased or decreased COP ; depending upon the type of refrigerant

Next steps