Related Questions

The angle of contact between a glass capillary tube of length 10 cm and a liquid is 90 degree . If the capillary tube is dipped vertically in the liquid, then the liquid:
A Will rise in the tube
B Will get depressed in the tube
C Will rise -up to 10 cm in the tube and will over flow
D Will neither rise nor fall in the tube.
The angle of contact between a glass capillary tube of length 10 cm and a liquid is 90 Degree. If the capillary tube is dipped vertically in the liquid, then the liquid:
A Will rise in the tube
B Will get depressed in the tube
C Will rise-up to 10 cm in the tube and will over flow
D Will neither rise not fall in the tube
Capillary rise of mercury in a small diameter tube is proportional to (where, d = diameter of the tube, σ = surface tension of mercury)
A d
B $$\frac{1}{{\text{d}}}$$
C $$\sigma $$
D $$\frac{l}{\sigma }$$
Applying a pressure drop across a capillary results in a volumetric flow rate 'Q' under laminar flow conditions. The flow rate for the same pressure drop, in a capillary of the same length but half the radius is
A $$\frac{{\text{Q}}}{2}$$
B $$\frac{{\text{Q}}}{4}$$
C $$\frac{{\text{Q}}}{8}$$
D $$\frac{{\text{Q}}}{{16}}$$
A glass tube of smaller diameter is used while performing an experiment for the capillary rise of water because
A It is easier to see through the glass tube
B Glass tube is cheaper than a metallic tube
C It is not possible to conduct this experiment with any other tube
D All of the above
For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it
A Decreases the pressure drop
B Decreases the outlet temperature of cooling medium
C Increases the overall heat transfer coefficient
D None of these
Pressure-enthalpy chart is useful in refrigeration. The change in internal energy of an ideal fluid used in ideal refrigeration cycle is
A Positive
B Negative
C Zero
D Infinity
Correction for capillary effect in manometers (used for pressure measurement) need not be applied, if diameter of the manometer tube is __________ mm.
A [

A.

B. > 4

B > 12.5
One Ton of Refrigeration is equal to the refrigeration effect corresponding to melting of 1000 kg of ice---
A In 1 hour
B In 24 hour
C In 10 minutes
D In 12 hour
A refrigeration cycle is a reversed heat engine. Which of the following has the maximum value of the co-efficient of performance (COP) for a given refrigeration effect?
A Vapor compression cycle using expansion valve
B Air refrigeration cycle
C Vapor compression cycle using expansion engine
D Carnot refrigeration cycle

Next steps