Which one of the following is the effect of blade shape on performance of a centrifugal compressor?

A Backward curved blades has poor efficiency
B Backward curved blades lead to stable performance
C Forward curved blades has higher efficiency
D Forward curved blades produce lower pressure ratio

Correct Answer: Forward curved blades produce lower pressure ratio

Forward curved blades produce lower pressure ratio is the main effect of blade shape on performance of a centrifugal compressor
Bissoy MCQ
#Mechanical Engineering #Compressors #Gas Turbines And Jet Engines

Related Questions

3/4th of square were taken to form shape A and the rest was made to form shape B. Shape A was divided into four equal squares (Shape C), what will be the ratio of the one shape C to one shape B.
A 1:4
B 3:16
C 1:2
D 3:4
In a centrifugal compressor, the ratio of the ________ to the blade velocity is called slip factor.
A Inlet whirl velocity
B Outlet whirl velocity
C Inlet velocity of flow
D Outlet velocity of flow
The ratio of outlet whirl velocity to blade velocity in case of centrifugal compressor is called
A Slip factor
B Velocity factor
C Velocity coefficient
D None of the above
Axial flow compressor has the following advantage over centrifugal compressor
A Larger air handling ability per unit frontal area
B Higher pressure ratio per stage
C Aerofoil blades are used
D Higher average velocities
In a centrifugal compressor, the flow of air is ________ to the axis of compressor.
A Parallel
B Perpendicular
C Inclined
D None of these
The variable required to be known in correlations used for estimating the horse power of a centrifugal gas compressor and hence its cost are P. Inlet pressure Q. Compressor rpm R. Delivery pressure S. Volumetric flow rate at inlet.
A P, Q and R
B P and R
C R and S
D P, R and S
The width of slot cut by a hacksaw blade is _______ the width of the blade.
A Equal to
B Less than
C Greater than
D None of these
To prevent the body of the blade from jamming in the saw cut, the teeth of blade are
A Strengthened
B Sharpened
C Set
D All of these
A turbine is said to have an axial discharge when the steam leaves the blade tip at _________ to the direction of the blade motion.
A 60°
B 90°
C 180°
D 270°
In impulse turbines, when friction is neglected, the relative velocity of steam at outlet tip of the blade is _________ the relative velocity of steam at inlet tip of the blade.
A Equal to
B Less than
C Greater than
D None of these

Next steps