Related Questions

A hacksaw blade is specified by its
A Length
B Material
C Width
D Number of teeth
The teeth of hacksaw blade are bent
A Towards right
B Towards left
C Alternately towards right and left and every third or fourth left straight
D May be bent in any direction
A hacksaw blade cuts on the
A Forward stroke
B Return stroke
C Both forward and return strokes
D Cutting depends upon the direction of force
If J is assigned to the seventh slot, the which of the following must be assigned to the fifth slot?
A K
B D
C B
D C
To prevent the body of the blade from jamming in the saw cut, the teeth of blade are
A Strengthened
B Sharpened
C Set
D All of these
A tailor had a number of shirt pieces to cut from some large pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute . How many large pieces would be cut in 24 minutes?
A 32
B 54
C 108
D 120
A tailor had a number of shirt pieces to cut from large piece pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute. How many large pieces would be cut in 24 minutes?
A 32
B 54
C 108
D 120
A tailor had a number of shirt pieces to cut from a roll of fabric. He cut each roll of equal length into 10 pieces. He cut at the rate of 45 cuts a minute. How many rolls would be cut in 24 minutes ?
A 32 rolls
B 54 rolls
C 108 rolls
D 120 rolls
A turbine is said to have an axial discharge when the steam leaves the blade tip at _________ to the direction of the blade motion.
A 60°
B 90°
C 180°
D 270°
In impulse turbines, when friction is neglected, the relative velocity of steam at outlet tip of the blade is _________ the relative velocity of steam at inlet tip of the blade.
A Equal to
B Less than
C Greater than
D None of these

Next steps