Related Questions

Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Select from the following non - Newtonian fluids in which the rate of shear deformation is a function of both shear stress and time - (1) Dilatant liquid (2) Bingham plastic liquid (3) Pseudoplastic liquid (4) Thixotropic liquid (5) Rheopectic liquid
Mohan traveled five cities (A, B, C, D and E) starting from home by a car which has a mileage such that the car can travel 10 km in 1 liter petrol. Distance between city A and B is twice the distance between home to city A. Distance between city B and C is thrice the distance between home to city A. Distance between city C and D is 100. Distance between city D and E is 1.5 times than the distance between B and C. Average distance traveled by Mohan was 41 km between five cities. Find how much petrol was needed by Mohan to travel from city B to D.
Which of the following factors are affecting critical shear stresses? 1. Purity of metals reduces the critical shear stress 2. Surface films greatly enhance the critical shear stress 3. Rise in temperature 4. Rate of deformation and the extent of initial deformation also help in raising the critical shear stress
A wall bracket is attached to the wall by means of 2 identical bolts, one at A and one at B. The force of 20kN acts at a distance of 400mm. Bolt A lies at a distance of 50mm from axis of tilt and bolt B 500mm. Allowable shear stress in the bolts is 100N/mm² and tensile is 40N/mm². Find the radius of Mohr circle which can be made from the shear stress and tensile stress acting on bolts.(Consider bolt under max stress and area of bolt is A)
Consider the following statements: 1. If x is directly proportional to z and y is directly proportional to z, then (x2 - y2) is directly proportional to z2. 2. If x is inversely proportional to z and y is inversely proportional to z, then (xy) is inversely proportional to z2. Which of the above statements is/are correct?
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
The Rheological behaviour of concrete, when represented by shear stress vs rate of shear, is characterized as Where : τ shear stress, Τ0 = (initial) yield value, μ = at-point plastic viscosity, γ̇ = at point rate of shear.
If nominal shear stress $${\tau _{\text{v}}}$$ exceeds the design shear strength of concrete $${\tau _{\text{c}}}$$, the nominal shear reinforcement as per IS : 456-1978 shall be provided for carrying a shear stress equal to
Shear stress versus shear rate behavior of four different types of fluids (I, II, III and IV) are shown in the figure below.
Basic Principles of Biotechnology mcq question image
Which one of the following options is correct?