Related Questions

Alcohol is used in manometers because
A it has low vapour pressure
B it is clearly visible
C it has low surface tension
D it can provide longer column due to low density
Correction for capillary effect in manometers (used for pressure measurement) need not be applied, if diameter of the manometer tube is __________ mm.
A [

A.

B. > 4

B > 12.5
Manometers measure the __________ pressure.
A Vacuum as well as the atmospheric
B Difference in
C Absolute
D Gage
Solution X contains 7% (by weight) of liquid M and solution Y contains 14.5% (by weight) of liquid M. If 3 grams of solution X is mixed with 2 grams of solution Y, then liquid M accounts for what percent of the weight of the resulting solution?
A 6.09%
B 10%
C 10.75%
D 21.5%
The angle of contact between a glass capillary tube of length 10 cm and a liquid is 90 degree . If the capillary tube is dipped vertically in the liquid, then the liquid:
A Will rise in the tube
B Will get depressed in the tube
C Will rise -up to 10 cm in the tube and will over flow
D Will neither rise nor fall in the tube.
The angle of contact between a glass capillary tube of length 10 cm and a liquid is 90 Degree. If the capillary tube is dipped vertically in the liquid, then the liquid:
A Will rise in the tube
B Will get depressed in the tube
C Will rise-up to 10 cm in the tube and will over flow
D Will neither rise not fall in the tube
The distillation carried out in such a way that the liquid with the lowest boiling point is first evaporated and re-condensed, then the liquid with the next higher boiling point is then evaporated and re-condensed, and so on until all the available liquid fuels are separately recovered in the sequence of their boiling points. Such a process is called
A Cracking
B Fractional distillation
C Full distillation
D Carbonisation
The property of a liquid which offers resistance to the movement of one layer of liquid over another adjacent layer of liquid, is called
A Surface tension
B Compressibility
C Capillarity
D Viscosity
The solvent used in liquid-liquid extraction should have __________ less than one.
A Selectivity
B Distribution co-efficient
C Both A & B
D Neither A nor B
Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
A 0.5 D
B D
C 1.5 D
D 2 D

Next steps