Related Questions

Selectivity of the solvent used in solvent extraction should be
A 1
B > 1
C 0
Solvent extraction is the terminology applied to the liquid-liquid extraction, which is preferred for the separation of the components of liquids, when
A Extracting solvent is cheaply & abundantly available
B One of the liquid components is heat sensitive
C Viscosity of liquid components is very high
D One of the liquid components has very high affinity towards the solvent
The solvent used in liquid extraction should not have high latent heat of vaporisation, because
A The pressure drop and hence the pumping cost will be very high
B It cannot be recovered by distillation
C Its recovery cost by distillation may be prohibitatively high
D It will decompose while recovering by distillation
'Solvent naphtha' used mostly as a solvent in paints and perfumery is produced by the __________ of virgin naphtha into small boiling range cuts.
A Steam reforming
B Distillation
C Desulphurisation
D None of these
In case of dry spinning of polymers, the polymer solution in a volatile solvent is forced through the spinnerates into a warm air chamber, where the solvent evaporates leaving behind the polymer in the filament form. Dry spinning is used for __________ fibres.
A Polythene
B PVC
C Rayon
D Polyvinyl acetate
Extraction of pencillin employs a __________ extraction coloumn.
A Centrifugal
B Packed
C Plate
D None of these
The vapour pressure of a solution (made by dissolving a solute in a solvent) is __________ that of the pure solvent.
A Less than
B More than
C Equal to
D Either more or less; depends on the solvent
Addition of a non-volatile solute to a solvent produces a __________ in its solvent.
A Freezing point elevation
B Boiling point depression
C Vapor pressure lowering
D All of the above
Solvent deoiling process is used for separating oil and soft wax from hard wax. Methyl iso-butyl ketone and methyl ethyl ketone (MEK) are two commonly used deoiling solvents. Use of former as the deoiling solvent has the advantages of the
A Elimination of solvent drying facility
B Higher nitration temperature
C Lower solvent dilution ratio
D All of the above
L is older than M and taller than N. O is younger than P, older than N and shorter than Q. R is older than S, younger than N, shorter than S and taller than Q. S is older than L, M, O, P, Q, R and S is necessarily false?
A O is the shortest of the group.
B N is the second tallest of the group.
C L is the tallest of the group.
D Q is the third oldest of the group.

Next steps