At the center line of a pipe flowing under pressure where the velocity gradient is zero, the shear stress will be

At the center line of a pipe flowing under pressure where the velocity gradient is zero, the shear stress will be Correct Answer Zero

In a pipe flowing under pressure, the velocity gradient represents the change in velocity across the cross-section of the pipe. When the velocity gradient is zero, it means that the velocity is constant at that point, and there is no change in velocity with respect to distance.

This condition occurs at the centerline of the pipe, where the velocity is at its maximum and is constant. Shear stress is the force parallel to the surface that one layer of fluid exerts on an adjacent layer as they slide past each other. When the velocity gradient is zero, it implies that there is no change in velocity, and, consequently, there is no relative motion between fluid layers.

As a result, the shear stress at the centerline of the pipe, where the velocity gradient is zero, will be Option C: Zero. There is no relative motion between fluid layers, so the shear stress is minimum or effectively non-existent at this location.
Bissoy MCQ

Related Questions

At the centre line of a pipe flowing under pressure where the velocity gradient is zero, the shear stress will be
The distance from pipe boundary, at which the turbulent shear stress is one-third die wall shear stress, is (where R is the radius of pipe)
A tank is filled by three pipes with uniform flow. The first two pipes operating simultaneously fill the tank in the same time during which the tank is filled by the third pipe alone. The second pipe fills the tank 5 hours faster than the first pipe and 4 hours slower than the third pipe. The time required by the first pipe is:
The strain energy stored in a body due to shear stress, is (where $$\tau $$ = Shear stress, C = Shear modulus and V = Volume of the body)
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
When a body is subjected to biaxial stress i.e. direct stresses ($${\sigma _{\text{x}}}$$) and ($${\sigma _{\text{y}}}$$) in two mutually perpendicular planes accompanied by a simple shear stress ($${\tau _{{\text{xy}}}}$$ ), then maximum shear stress is
When a body is subjected to a direct tensile stress ($${\sigma _{\text{x}}}$$) in one plane accompanied by a simple shear stress ($${\tau _{{\text{xy}}}}$$ ), the maximum shear stress is
According to maximum shear stress failure criterion, yielding in material occurs, when the maximum shear stress is equal to __________ times the yield stress.
Shear stress in a fluid flowing in a round pipe
The shear force at the center of a simply supported beam with a gradually varying load from zero at both ends to w per meter at the center, is