Related Questions

High pressure steam is expanded adiabati-cally and reversibly through a well insulated turbine, which produces some shaft work. If the enthalpy change and entropy change across the turbine are represented by ΔH and ΔS respectively for this process:
A ΔH = 0 and ΔS = 0
B ΔH ≠ 0 and ΔS = 0
C ΔH ≠ 0 and ΔS ≠ 0
D ΔH = 0 and ΔS ≠ 0
Which of the following parameter can be adjusted by modifying the tie rod attachment length?
A Camber
B Caster
C Toe
D Steering gear ratio
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm
The specific speed of a turbine is the speed of an imaginary turbine, identical with the given turbine, which
A Delivers unit discharge under unit head
B Delivers unit discharge under unit speed
C Develops unit power under unit head
D Develops unit power under unit speed
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm
In gramophones for adjusting the speed of the turntable, the following type of governor is commonly employed
A Hartung governor
B Wilson Hartnell governor
C Pickering governor
D Inertia governor
For adjusting a quadrilateral whose both the diagonals are observed, the equations of conditions involved, are
A Two angle equations and two side equations
B One angle equation and three side equations
C Three angle equations and one side equation
D None of these
Transit rule of adjusting the consecutive coordinates of a traverse is used where
A linear and angular measurements of the traverse are of equal accuracy
B angular measurements are more accurate than linear measurements
C linear measurements are more accurate than angular measurements
D all of the above
The trial balance shows Supplies Tk 0 and Supplies Expense Tk 1,500. If Tk 800 of Supplies are on hand at the end of the period, the adjusting entry is:
A debit Supplies Tk 800 and credit Supplies Expense Tk 800.
B debit Supplies Expense Tk 800 and credit Supplies Tk 800.
C debit Supplies Tk 700 and credit Supplies Expense Tk 700.
D debit Supplies Expense Tk 700 and credit Supplies Tk 700.
E None of these
The reconciling item in a bank reconciliation that will result in an adjusting entry by the depositor is:
A deposit in transit.
B bank service charges.
C a bank error.
D outstanding checks.
E None of these

Next steps