Related Questions

If both Stirling and Carnot cycles operate within the same temperature limits, then efficiency of Stirling cycle as compared to Carnot cycle
A More
B Less
C Equal
D Depends on other factors
Efficiency of a heat engine working on Carnot cycle between two temperature levels depends upon the
A Two temperatures only
B Pressure of working fluid
C Mass of the working fluid
D Mass and pressure both of the working fluid
The efficiency of Stirling cycle is __________ Carnot cycle.
A Greater than
B Less than
C Equal to
D None of these
The efficiency of Ericsson cycle is __________ Carnot cycle.
A Greater than
B Less than
C Equal to
D None of these
Otto cycle efficiency is higher than Diesel cycle efficiency for the same compression ratio and heat input because in Otto cycle
A Heat rejection is lower
B Expansion and compression are isentropic
C Combustion is at constant volume
D Maximum temperature is higher
The efficiency of a Carnot engine depends on
A Working substance
B Design of engine
C Size of engine
D Temperatures of source and sink
একটি কর্নো ইঞ্জিন 500 K এবং 205 K তাপমাত্রার দুইটি আধারের মাধ্যমে পরিচালিত হয়। প্রত্যেক চক্রে ইঞ্জিন যদি উৎস থেকে 1 kcal তাপ গ্রহণ করে তাহলে প্রত্যেক চক্রে তাপ গ্রাহকে তাপ বর্জন করার পরিমাণ কত? ( A Carnot engine is operated between two reservoirs at temperatures of 500 K and 250K. If the engine receives 1 kcal of heat from the source in each cycle, the amount of heat rejected to the sink in each cycle is-)
A 500 cal
B 1000 cal
C 500 kcal
D 10 kcal
একটি কার্নো ইঞ্জিন 500K এবং 250K তাপমাত্রার দুইটি আধারের মাধ্যমে পরিচালিত হয়। প্রত্যেক চক্রে ইঞ্জিন যদি উৎস থেকে । kcal তাপ গ্রহণ করে তাহলে প্রত্যেক চক্রে তাপ গ্রাহকে তাপ বর্জন করার পরিমাণ কত? ( A Carnot engine is operated between two reservoirs at temperatures of 500 K and 250 K. If the engine receives 1 kcal of heat from the source in cach cycle, the amount of heat rejected to the sink in each cycle is --)
A 500 cal
B 1000 cal
C 500 kcal
D 10 kcal
Carnot cycle is also termed as the constant __________ cycle in thermodynamics.
A Entropy
B Pressure
C Volume
D Heat
The thermodynamic difference between a Rankine cycle working with saturated steam and the Carnot cycle is that
A Carnot cycle can't work with saturated steam
B Heat is supplied to water at temperature below the maximum temperature of the cycle
C A Rankine cycle receives heat at two places
D Rankine cycle is hypothetical

Next steps