Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
The questions given below are in the form of a statement followed by assumptions 1 and 2. You may assume that everything stated in the statement is true, then consider the two assumptions and decide which of them logically follows, beyond a reasonable doubt, from the information in the statement. Statements: The policy of subsidizing high-yielding varieties of seeds (HYVs) has been adopted in the five-year plans in India. Assumptions: 1. High Yielding Variety Seeds (HYV) will increase productivity in the agriculture sector. 2. Normal seeds are relatively less productive as compared to high-yielding variety (HYV).
Stress analysis of structural material for the submarine gives the state of stress as shown in the figure. The yield strength of the material is 450 MPa. Using Von-mises yielding criteria determine whether yielding will occur or not? If not, what is the factor of safety?
Stress analysis of structural material for the submarine gives the state of stress as shown in the figure. The yield strength of the material is 450 MPa. Using Tresca’s yielding criteria determine whether yielding will occur or not? If not, what is the factor of safety?
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Which of the following statements regarding stress related factors is/are true and false?
1. Burnout Stress Syndrome (BOSS) is a debilirating psychological condition brought about by unrelieved work stress.
2. 'Good' and 'bad' stresses are also referred to as 'Distress' and 'Eustress' respectively.
3. It is natural and healthy to maintain optimal level of stress.
4. Rustout Stress Syndrome (ROSS) is indicative of stress overload.
5. Anxiety is a state of emotional tension characterised by Apprehension, fearfulness, and psychic pain.
Lower stress is required to initiate yielding.
The yielding criteria are primarily empirical relations. Pure hydrostatic stress causes the yielding in continuous solid.
According to maximum shear stress failure criterion, yielding in material occurs, when the maximum shear stress is equal to __________ times the yield stress.