Related Questions

A tank is filled by three pipes with uniform flow. The first two pipes operating simultaneously fill the tank in the same time during which the tank is filled by the third pipe alone. The second pipe fills the tank 5 hours faster than the first pipe and 4 hours slower than the third pipe. The time required by the first pipe is:
A 6 hours
B 10 hours
C 15 hours
D 30 hours
Pipe A alone can fill a tankin 8 hours .Pipe B can fill it in 6 hours . If both the pipes are operated and after 2 hours pipe A is closed, then the other pipe will fill the tank in.
A 6 hours
B 3 1/2 hours
C 4 hours
D 1 1/2 hours
A pipe fills a tank in P minuties and another pipe fills the tank in Q minutes. A different pipe makes the tank empty in R minutes. If all these three pipe are opened then in how many minutes the tank will be full?
A p+q-qpqr
B pq+pr-pqpqr
C pq+qr-prpqr
D pqrqr+pr-pq
A water tank with 64-gallon capacity is filled by pipe A and emptied by pipe B. If the rate of water flow through pipe A is 2 gallons per hour, how many gallons per hour should flow through pipe B so that when both pipes are open, the initially empty tank shold be full in exactly 96 hours?
A 3/8
B 4/3
C 2/3
D 8/3
Pipe A can fill an empty cistern in 4 hours while along with Pipe B it can fill it up in 3 hours. Only Pipe A is turned on for an hour after which Pipe B is also turned on. How much total time will it take to fill up the cistern?
A 3 hrs 20 min
B 3 hrs 25 min
C 3 hrs 15 min
D 3 hrs
For the same diameter and thickness of tube, a water tube boiler has ________ heating surface as compared to fire tube boiler.
A More
B Less
C Equal
D None of these
For the same diameter and thickness of tube, a water tube boiler compared to a fire tube boiler has
A More heating surface
B Less heating surface
C Equal heating surface
D Heating surface depends on other parameters
In most of the shell and tube heat exchangers, the tube pitch is generally __________ the tube diameter.
A Less than
B 1.25-1.50 times
C 2.5 times
D One-fourth of
Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.
A 1.25
B 1.75
C 2.5
D 3.5
In a shell and tube heat exchanger, the tube side heat transfer co-efficient just at the entrance of the tube is
A Infinity
B Zero
C Same as average heat transfer co-efficient for tube side
D None of these

Next steps