Related Questions

Endurance is a measure of fatigue limit of a metal. Fatigue crack in nitrided machine parts originates
A At the surface
B Within the core
C Just below the surface
D Anywhere on the surface
The yield point in fatigue loading compared to that in static loading is less. The ratio of ultimate tensile strength to endurance limit of a material subjected to fatigue loading is
A 0.5
B 1
C 1.5
D 2
Failure of a material is termed as fatigue failure, if it fails below the yield point. The resistance to fatigue failure of a material is measured by the
A Ultimate tensile strength (U.T.S.)
B Endurance limit
C Elastic limit
D None of these
Fatigue limit improvement by over stressing the metal by successively increasing the load is called coaxing. In fatigue failure, the material fails
A Below the yield point
B Above the yield point
C Below the elastic limit
D At the elastic limit
K produces 100 parts twice as fast as G does. G produces 100 parts in 40 minutes. If each produces parts at a constant rate, how many parts will K produces in 6 minutes.
A 30
B 25
C 20
D 15
Based on the information below, how much did a certain telephone call cost? 1. The call lasted 1 minute 27 seconds 2. The cost for the first 30 second unit is Tk. 1.80, call duration more than 30 seconds costs Tk. 0.90 per 30 second unit 3. Any call duration less than 30 seconds is rounded up to the nearest 30-second unit.
A Tk. 1.80
B Tk. 2.61
C Tk. 2.70
D Tk. 3.51
In nitrated parts, the origins of the fatigue cracks will occur at
A Surface
B Just below the surface
C Within the core
D None of the above
Which of the following is not correct procedure to increase the fatigue limit?
A Cold working
B Shot peening
C Surface decarburisation
D Under stressing
Fatigue life is expected to increase by
A increasing the size of the sample
B smooth polishing of the surface of the sample
C having compressive residual stresses at the surface
D having tensile residual stresses at the surface
__________ can not increase the fatigue strength of a material.
A Grain refining
B Grain coarsening
C Surface hardening
D Shot peening

Next steps