Related Questions

The yield point in fatigue loading compared to that in static loading is less. The ratio of ultimate tensile strength to endurance limit of a material subjected to fatigue loading is
A 0.5
B 1
C 1.5
D 2
Endurance is a measure of fatigue limit of a metal. Fatigue crack in nitrided machine parts originates
A At the surface
B Within the core
C Just below the surface
D Anywhere on the surface
Fatigue limit improvement by over stressing the metal by successively increasing the load is called coaxing. In fatigue failure, the material fails
A Below the yield point
B Above the yield point
C Below the elastic limit
D At the elastic limit
Endurance limit or fatigue limit is the maximum stress that a member can withstand for an infinite number of load applications without failure when subjected to
A Dynamic loading
B Static loading
C Combined static and dynamic loading
D Completely reversed loading
On Dhaka- Sylet highway , 5% of the drives are fined for exceeding the speed limit. However , 80% of the drivers who exceed the speed limit are not fined. What percentage of dirvers on this highway exceed the speed limit?
A 10
B 15
C 20
D 25
Failure of a material is termed as fatigue failure, if it fails below the yield point. The resistance to fatigue failure of a material is measured by the
A Ultimate tensile strength (U.T.S.)
B Endurance limit
C Elastic limit
D None of these
Which of the following is not the correct method of increasing fatigue limit?
A Shot peening
B Nitriding of surface
C Cold working
D Surface decarburisation
The endurance or fatigue limit is defined as the maximum value of the stress which a polished standard specimen can withstand without failure, for infinite number of cycles, when subjected to
A Static load
B Dynamic load
C Static as well as dynamic load
D Completely reversed load
When a material is subjected to fatigue loading, the ratio of the endurance limit to the ultimate tensile strength is
A 0.20
B 0.35
C 0.50
D 0.65
If the size of a standard specimen for a fatigue testing machine is increased, the endurance limit for the material will
A Have same value as that of standard specimen
B Increase
C Decrease
D None of these

Next steps