Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

A fillet-welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets are of 10 mm size and the weld length is 30 mm. If the allowable shear stress of the weld is 94 MPa, considering the minimum throat area of the weld, the maximum allowable transverse load per weld in kN is
Consider the following statements regarding welded and riveted joints 1. Welded assemblies are tight and leak proof as compared with riveted assemblies. 2. Single-welded V-joint is less reliable than square butt joint. 3. Welding results in a thermal distortion of the parts, thereby inducing residual stresses. Which of the above statements is/are correct ?
In a transverse fillet welded joint, the size of weld is __________ the throat of weld.
Which of the following statement(s) is/are true regarding butt welding? 1. Flash butt welding is a combination of resistance, arc and pressure welding 2. Upset butt welding is used for welding rods 3. Percussion Welding is a self timing spot welding method 4. Aluminium alloys are flash welded
The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, $$l$$ = Length of weld and $${\sigma _{\text{t}}}$$ = Allowable tensile stress for weld metal)
In butt weld joint, what will be the strength equation? if the thickness of the plate is t, permissible tensile stress for the weld is σt, and the length of the weld is l.
Why is double cover butt joint preferred over single cover butt joint or lap joint?
Which of the following statements are correct in respect of welded connections? 1) Strength of Butt weld is equal to the strength of components joined. 2) Fillet welds carry the loads computed based on the tensile strength characteristics of fusion material. 3. for effective transmission of load by fillet weld, the fusion faces shall subtend an angle between 60° and 120° 
Two plates of 12mm and 16mm thickness are to be joined by groove weld. The joint is subjected to factored tensile load of 400kN. Due to some reasons the effective length of weld that could be provided was 150mm only. What is the safety of joint if single-V groove weld is provided?
A butler stole wine from a butt of sherry which contains 15% of spirit and he replaced what he had stolen with wine containing 6% of spirit. The butt was then 9% strong only. How much of the butt did he steal?