Related Questions

In DC arc welding, if leads are arranged in work as Negative pole of the welding arc and electrode as Positive pole of the welding arc, the arrangement is known as
A Fusion
B Reverse polarity
C Forward welding
D Direct polarity
When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as ________ double cover butt joint.
A Single riveted
B Double riveted
C Multi riveted
D None of these
When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as _______ double cover butt joint.
A Single riveted
B Double riveted
C Both (A) and (B)
D None of these
If a gas metal arc process uses a low arc voltage and the arc is continuously interrupted as the molten electrode metal fills up the arc gap is known as
A ARC
B Short ARC
C ARC length
D ARC blow
In a metal arc welding process, a gas metal arc welding with magnetized flux is used and can be done in all the positions i.e. flat position, vertical position or inclined position.
A Globular transfer
B Spray transfer
C GMAW practice
D Dip transfer
In leaf springs, the maximum bending stress developed in the plates is (where W = Load acting on the spring, $$l$$ = Span of the spring, n = Number of plates, b = Width of plates and t = Thickness of plates)
A $$\frac{{{\text{W}}l}}{{{\text{nb}}{{\text{t}}^2}}}$$
B $$\frac{{3{\text{W}}l}}{{2{\text{nb}}{{\text{t}}^2}}}$$
C $$\frac{{2{\text{W}}l}}{{{\text{nb}}{{\text{t}}^2}}}$$
D $$\frac{{3{\text{W}}l}}{{{\text{nb}}{{\text{t}}^2}}}$$
পাত-দূরত্ব d এবং ধারকত্ব C. এমন একটি সমান্তরাল পাত ধারকের পাত দুটির মাঝখানে d/2 পুরুত্ববিশিষ্ট একটি ধাতব পাত স্থাপন করা হলো। নতুন ধারকত্ব কত হবে? (A metal plate of thickness d/2 is inserted between the plates of a parallel plate capacitor with plate separation d and capacitance C. What is the new capacitance?)
A C/d
B C/2
C 4Cd
D 2c
The electrode tip diameter (d) in spot welding should be equal to (where t = Thickness of plate to be welded)
A $$\sqrt {\text{t}} $$
B 1.5 t
C 3 t
D 6 t
When two plates are butt together and riveted with cover plates with two rows of rivets, the joint is known as
A Lap joint
B Butt joint
C Single riveted single cover butt joint
D Double riveted double cover butt joint
The overlap of batten plates with the main members in welded connections should be more than (where t = thickness of the batten plate)
A 3t
B 4t
C 6t
D 8t

Next steps