Related Questions

Items of property, plant and equipment can be recognized as assets when their cost can be measured reliably and it is likely that the future economic benefits associated with the assets:
A will increase gradually
B Will flow to entity
C Will diminish with the passage oftime
D Won't be available
A company reports sales revenue of Tk. 200 million the current year and Tk. 180 million last year. Their total assets in the current year are Tk. 150 million and last year's total assets were Tk. 130 million . What is the current year's asset turnover ratio ?
A 1.48
B 1.33
C 1.36
D 1.43
Situation in which company replaces existing assets with new assets is classified as
A replacement projects
B new projects
C existing projects
D internal projects
What is the process of evaluating IT assets, their importance to the organization, and their susceptibility to threats, to measure the risk exposure of these assets?
A Risk management
B Risk assessment
C Security
D None of the above
Mahesh ran a business on borrowed capital. After his sudden demise, all the creditors are doing their best to go after Mahesh’s assets. Which of the below assets is beyond the reach of the creditors?
A Property under Mahesh's name
B Mahesh's bank accounts
C Term life insurance policy purchased under section 6 of the MWP Act
D Mutual funds owned by Mahesh
With regards to valuation of assets by insurance companies, _________ is the value at which the life insurer has purchased or acquired its assets.
A Discounted future value
B Discounted present value
C Market value
D Book value
Which of the following is not the value the key property will hold if the key is a function key?
A F8
B F2
C F9
D Left
When assigning a shortcut key to a symbol, you should always try to select a key or key combination that is:
A Unassigned
B Located on the ten-key pad section of your keyboard.
C Assigned to another task.
D From the same font family as the symbol.
A taper key which fits half in the key way of the hub and half in the key way of shaft, is known as
A sunk key
B flat saddle key
C hollow saddle key
D tangent key
When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be
A 0.8 d
B 1.2 d
C 1.57 d
D 1.8 d

Next steps