What does EXT indicator on status bar of MS Word indicate?

A It indicates whether the external text is pasted on document or not
B It indicates whether extended add-ons are installed on MS Word or not
C It indicates whether Extended Selection mode is turned on or off
D None of These

Correct Answer: It indicates whether Extended Selection mode is turned on or off

EXT indicator indicates whether or not Extend Selection Mode is turned off or on. Pressing F8 turns it on and it anchors the cursor. If we press any arrow keys at that point the text will be selected from the anchor point. The Status Bar indicates that we are in Extend Selection mode. (In versions of Word earlier than 2007, the status bar indicates EXT.) Pressing the Escape key will take us out of Extend Selection mode.
Bissoy MCQ
#Computer Fundamentals #MS Word

Related Questions

When a bar of length '$$l$$' and diameter 'd' is rigidly fixed at the upper end and hanging freely, then the total elongation produced in the bar due to its own weight is (where w = Weight per unit volume of the bar)
A $$\frac{{{\text{w}}l}}{{2{\text{E}}}}$$
B $$\frac{{{\text{w}}{l^2}}}{{2{\text{E}}}}$$
C $$\frac{{{\text{w}}{l^3}}}{{2{\text{E}}}}$$
D $$\frac{{{\text{w}}{l^4}}}{{2{\text{E}}}}$$
The area of actual indicator diagram on an air compressor as compared to area of ideal indicator diagram is
A Less
B More
C Same
D More/less depending on compressor capacity
Your switch has a port status LED that is alternating between green and amber. What could this indicate?
A The port is experiencing errors
B The port is shut down
C The port is in STP blocking mode
D Nothing, this is normal.
When heated an iron bar expands 0.2% . If the increased length is 1cm , what is the original length of the bar ?
A 500cm
B 5cm
C 0.97cm
D 1.97cm
20°C  তাপমাত্রায় ও 1.5 bar চাপে একটি গ্যাস     0.1m3 আয়তন দখল করে। যদি গ্যাসের চাপ 7.5 bar এ সঙ্কুচিত করার ফলে   0.04m3    আয়তন দখল করে, তবে গ্যাসের শেষ তাপমাত্রা বাহির কর।
A    293°C  
B 313°C    
C     586°C 
D       213°C     
If a load W is applied instantaneously on a bar; Then the stress induced in bar will
A Be independent of ratio of mass of load W to mass of bar (y)
B Increase with increase in y
C Decrease with decrease in y
D Depend on other considerations
The elongation of a conical bar under its own weight is __________ that of prismatic bar of the same length.
A Equal to
B Half
C One-third
D Two-third
A simply supported uniform rectangular bar breadth b, depth d and length L carries an isolated load W at its mid-span. The same bar experiences an extension e under same tensile load. The ratio of the maximum deflection to the elongation, is
A $$\frac{{\text{L}}}{{\text{d}}}$$
B $$\frac{{\text{L}}}{{2{\text{d}}}}$$
C $${\left( {\frac{{\text{L}}}{{2{\text{d}}}}} \right)^2}$$
D $${\left( {\frac{{\text{L}}}{{3{\text{d}}}}} \right)^2}$$
A bar L metre long and having its area of cross-section A, is subjected to a gradually applied tensile load W. The strain energy stored in the bar is
A $$\frac{{{\text{WL}}}}{{2{\text{AE}}}}$$
B $$\frac{{{\text{WL}}}}{{{\text{AE}}}}$$
C $$\frac{{{{\text{W}}^2}{\text{L}}}}{{{\text{AE}}}}$$
D $$\frac{{{{\text{W}}^2}{\text{L}}}}{{2{\text{AE}}}}$$
The length of the lap in a compression member is kept greater than bar diameter x (Permissible stress in bar / Five times the bond stress) or
A 12 bar diameters
B 18 bar diameters
C 24 bar diameters
D 30 bar diameters

Next steps