Related Questions

The distance from district X to district Y is fifty miles. District Z is sixty miles from district Y. Which of the following could be the distance form district X to district Z? i. 110 miles, ii. 10 miles, iii. 70 miles.
A i only
B ii only
C ii and iii only
D i, ii or iii
Negative consumer reaction to a product is generated by a perceived gap between consumer expectation and product performance. Businesses should use advertising to adjust consumer expectations to coincide with their product performances. which of the following , if true, would most weaken the argument above?
A Most consumers can assess the actual performance of the products they purchase.
B Unless consumer expectations about a product are sufficiently high, consumers will not purchase that product.
C Most consumer purchase products based upon their brand name instead of their past performance.
D Expectations of most consumer are influenced by the claims made for those products by the manufacturers.
What fee is payable by the aggrieved person to the District Consumer Forum while filing his complaint?
A Rs.250
B Rs.100
C 10% of the relief sought and given
D No fee is payable
On Dhaka- Sylet highway , 5% of the drives are fined for exceeding the speed limit. However , 80% of the drivers who exceed the speed limit are not fined. What percentage of dirvers on this highway exceed the speed limit?
A 10
B 15
C 20
D 25
Which one of the following constitutional authorities inquires and decides in case of doubts and disputes arising out of election of the President and Vice President Of India?
A The Supreme Court of India
B The Election Commission of India
C The Parliamentary Committee
D The High Court of Delhi
If the natural water content of soil mass lies between its liquid limit and plastic limit, the soil mass is said to be in
A liquid state
B plastic state
C semi-solid state
D solid state
When the plastic limit of a soil is greater than the liquid limit, then the plasticity index is reported as
A negative
B zero
C non-plastic (NP)
D 1
The difference between the upper limit and lower limit of a dimension is called
A Nominal size
B Basic size
C Actual size
D Tolerance
The ratio of endurance limit in shear to the endurance limit in flexure is
A 0.33
B 0.4
C 0.5
D 0.55
The endurance limit in shear of carbon steel can be obtained by multiplying the endurance limit in flexure by a factor of
A 0.45
B 0.55
C 0.65
D 0.75

Next steps