Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

With regard to computer memory, which of the following statement(s) is/are TRUE?  (A) Cache memory is 'volatile' memory. (B) Magnetic memory is 'volatile' memory.  (C) Flash memory is 'volatile' memory. (D) RAM is 'volatile' memory. Choose the correct answer from the option given below:
The advantage of I/O mapped devices to memory mapped is ___________
A linear Hamming code is used to map 4-bit messages to 7-bit codewords. The encoder mapping is linear. If the message 0001 is mapped to the codeword 0000111, and the message 0011 is mapped to the codeword 1100110, then the message 0010 is mapped to
Microcontrollers are used in automatically controlled products and devices, such as automobile engine control systems, implantable medical devices, remote controls, office machines, appliances, power tools, toys and other embedded systems. By reducing the size and cost compared to a design that uses a separate microprocessor, memory, and input/output devices, microcontrollers make it economical to digitally control even more devices and processes. Mixed signal microcontrollers are common, integrating analog components needed to control non-digital electronic systems. What inference can be drawn from the above?
Consider a machine with a byte addressable main memory of 220 bytes, block size of 16 bytes and a direct mapped cache having 212 cache lines. Let the addresses of two consecutive bytes in main memory be (E201F)16 and (E2020)16. What are the tag and cache line address (in hex) for main memory address (E201F)16?
A shared variable x, initialized to zero, is operated on by four concurrent processes W, X, Y, Z as follows. Each of the processes W and X reads x from memory, increments by one, stores it to memory, and then terminates. Each of the processes Y and Z reads x from memory, decrements by two, stores it to memory, and then terminates. Each process before reading x invokes the P operation (i.e., wait) on a counting semaphore S and invokes the V operation (i.e., signal) on the semaphore S after storing x to memory. Semaphore S is initialized to two. What is the maximum possible value of x after all processes complete execution?
Consider a process executing on an operating system that uses demand paging. The average time for a memory access in the system is M units if the corresponding memory page is available in memory, and D units if the memory access causes a page fault. It has been experimental measured that the average time taken for a memory access in the process is X units. Which one of the following is the correct expression for the page fault rate experienced by the process?
Which of the following statement about computer memory are true?  A. Secondary storage is non-volatile storage.  B. Video memory found in graphics cards is volatile memory.  C. Primary memory (RAM) is the fastest form of memory in a computer.  Choose the correct answer from the options given below:
Assume a memory access to main memory on a cache "miss" takes 30 ns and a memory access to the cache (on a cache "hit") takes 3 ns. If 80% of the processor's memory requests results in a cache "hit", what is the average memory access time?
Which one of the following is true with regard to a CPU having a single interrupt request line and single interrupt grant line? i) Neither vectored nor multiple interrupting devices is possible. ii) Vectored interrupts is not possible but multiple interrupting devices is possible. iii) Vectored interrupts is possible and multiple interrupting devices is not possible. iv) Both vectored and multiple interrupting devices are possible.