Related Questions

Which of the following is considered to be the destination host before translation?
A Inside local
B Outside local
C Inside global
D Outside global
In covering a certain distance , the speeds of A and B are in the ratio of 3 : 4. A takes 30 minutes more than B to reach the destination. The time taken by A to reach the destination is :
A 1.0 hour
B 1.5 hours
C 2.0 hours
D 2.5 hours
when a truck travels at 60 miles per hour, it uses 30 percent more gasoline to travel andy distance than it does when it travels at 50 miles per hour. The truck can travel 20 miles on a gallon of gas if it is travelling at 50 miles per hour. The truck has only 10 gallons of gas and is 160 miles from its destination. It takes 20 minutes for the truck to stop for gas . How long will it take the truck to reach its final destination if it is driven at 60 miles per hour?
A 160 minutes
B 180 minutes
C 190 minutes
D 192 minutes
Two bikes start at he same time from two destination 200 km apart and traved towards each other. If they cross each other at a distance of 130 km from one of the destination, what is the ratio of their speeds?
A 17:13
B 7:3
C 1:3
D 2:3
A host machine is unable to communication with Google server. Which command is the most appropriate to run at host machine to determine which intermediary device is responsible for this failure ?
A talnet 192.168.1.1
B ping 192.168.1.1
C trcert 192.168.1.1
D ftp 192.168.1.1
A host machine is unable to communicate with Google server . Which command is the most appropriate to run at host machine to determine which intermediary device is responsible for this failure?
A relnet 192.168. 1.1
B ping 192. 168.1.1
C tracert 192. 168.1.1
D fip 192.168.1.1
How many bits internet address is assigned to each host on a TCP/IP internet which is used in all communications with the host?
A 16 - bits
B 32 - bits
C 48 - bits
D 64 - bits
E None of the above
A receiving host has failed to receive all of the segments that it should acknowledge. What can the host do to improve the reliability of this communication session?
A Send a different source port number
B Restart the virtual circuit
C Decrease the sequence number
D Decrease the window size
You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?
A The router is not configured for the new host
B The VTP configuration on the switch is not updated for the new host
C The host has an invalid MAC address
D The switch port the host is connected to is not configured with the correct VLAN membership
End-to-end connectivity is provided from host-to-host in:
A Network layer
B Session layer
C Data link layer
D Transport layer
E None of the above

Next steps