What command will display the line, protocol, DLCI, and LMI information of an interface?

What command will display the line, protocol, DLCI, and LMI information of an interface? Correct Answer <i class="networking-code">show interface</i>

The show interface command shows the line, protocol, DLCI, and LMI information of an interface.
Bissoy MCQ

Related Questions

Which command is used to display the subdirectory structure of the currently logged drive and pause the screen display after each screenful of information?
Which command is used to display the subdirectory structure of the currently logged drive and pause the screen display after each screen full of the information?
While working with MS-DOS, which command is used to display the contents of a file and pause the display after each screenful of information?
The ratio of the length to the width of a rectangular advertising display is approximately 3.3 to 2. If the width of the display is 8 meters, what is the approximate length of the display, in meters?
What standard, protocol or language was generalized to become a standard protocol for sending messages of any type, using any protocol?
While working with MS-DOS, which command is used to switch to the monochrome display from color display?
What command is used to stop RIP routing updates from exiting out an interface but still allow the interface to receive RIP route updates?
Which command will be used to display file and directory names only, without size, date, and time information?
You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?
Which command be used to clear the screen and display the operating system prompt on the first line of thedisplay?