Bissoy.com
Doctors Medicines MCQs Q&A

In a typical n-p-n transistor, the doping concentrations in emitter, base and collector regions are CE, CB and CC respectively. These satisfy the relation,

In a typical n-p-n transistor, the doping concentrations in emitter, base and collector regions are CE, CB and CC respectively. These satisfy the relation, Correct Answer C<sub>E</sub> &gt; C<sub>C</sub> &gt; C<sub>B</sub>

Related Questions

For transistor action (a) Base, emitter, and collector regions should have similar size and doping concentrations. (b) The base region must be very thin and lightly doped. (c) The emitter-base junction is forward biased and the base-collector junction is reverse biased. (d) Both the emitter-base junction as well as the base-collector junction are forward biased. Which one of the following pairs of statements is correct?
For a narrow base PNP BJT, the excess minority carrier concentrations (ΔnE for emitter, ΔpB for base, ΔnC for collector) normalized to equilibrium minority carrier concentrations (nE0 for emitter, pB0 for base, nC0 for collector) in the quasi-neutral emitter, base and collector regions are shown below. Which one of the following biasing modes is the transistor operating in?
Choose the right option among the alternatives – A transistor conducts in its forward direction when its collector/emitter/base, is positive with respect to its collector/emitter/base, and when a turn-on voltage or current signal is applied to its collector/emitter/base.
A transistor is used in common emitter mode as an amplifier. Then a. The base-emitter junction is forward biased b. The base-emitter junction is reverse biased  c. The input signal is connected in series with the voltage applied to the base-emitter junction  d. The input signal is connected in series with the voltage applied to bias the base-collector junction Which of the following statement is true?
Which of the following conditions must be satisfied for a transistor to be in saturation? 1. Its collector to base junction should be under forward bias 2. Its collector to base junction should be under reverse bias 3. Its emitter to base junction should be under reverse bias 4. Its emitter to base junction should be under forward bias Which of the above conditions are correct?
In the following question, two statements are given each followed by two conclusions I and II. You have to consider the statements to be true even if they seem to be at variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statements. Statement: (I) 28 athletes are facing legal cases due to doping incidents. (II) The new wave of Olympic doping cases is based on evidences. Conclusions: (I) The report of doping is based on the test that happen. (II) Doping practice is very common these days among athletes.
In the following question, two statements are given each followed by two conclusions I and II. You have to consider the statements to be true even if theyseem to be at variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statements.
Statement:
(I) 28 athletes are facing legal cases due to doping incidents.
(II) The new wave of Olympic doping cases is based on evidences.
Conclusions:
(I) The report of doping is based on the test that happen.
(II) Doping practice is very common these days among athletes.
Consider the following statements regarding an N-P-N Bipolar Junction Transistor: 1. Emitter diode is forward biased and the collector diode is reverse biased 2. Emitter has many free electrons 3. Free electrons are injected into the base and pass through the collector 4. Depletion layers around junction J1 and J2 of BJT are widened. Which of the above statements are correct?
In a uniformly doped BJT, assume that NE, NB and NC are the emitter, base and collector doping in atoms/cm3, respectively. If the emitter injection efficiency of the BJT is close to unity, which one of the following conditions is TRUE?
In NPN transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in