Bissoy.com
Doctors Medicines MCQs Q&A

A second order phase transition is one in which

A second order phase transition is one in which Correct Answer the plot of specific heat as a function of temperature shows a discontinuity

Related Questions

Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
What is the correct order of the following phases of training?
1. Development Phase
2. Design Phase
3. Need Analysis Phase
4. Implementation Phase
5. Evaluation Phase
Arrange the following demographic transition theory given by Blackur (ascending order)
1. Declining phase with low mortality, lower fertility
2. Low stationary phases with low fertility and low mortality
3. Early expanding phase marked by high fertility
4. High stationary phase marked by high fertility and mortality
In a first order phase transition, at the transition temperature, specific heat of the system
When a 1-phase transformer is connected in parallel, there are four conditions for proper parallel operation, but when two or 3-phase transformer paralleling is done, there are two additional points along with those four conditions applied for 1-phase. Statement 1 - The phase sequence must be the same. Statement 2 - The phase shift between primary and secondary voltages must be the same for all transformers connected in parallel. From the above two Statements (s), which is/are the correct conditions in this regard?
Election for a constituency was conducted in two phases where three contestants A, B and C contested. In first phase 48% of the total voters voted out which A and B got 32% and 46% of the votes (remaining to C). In the next phase where 75% of the remaining people voted A and B got 43% and 33% of the votes casted (Remaining to C). If the amount of votes obtained by A in phase 1 is less than the total votes obtained by B in phase 1 and C in phase 2 by 16080, then what is the total number of voters in the constituency?
A three-phase cylindrical rotor synchronous generator has a synchronous reactance Xs and a negligible armature resistance. The magnitude of per phase terminal voltage is VA and the magnitude of per phase induced emf is EA. Considering the following two statements, P and Q, P: For any three-phase balanced leading load connected across the terminals of this synchronous generator, VA is always more than EA Q: For any three-phase balanced lagging load connected across the terminals of this synchronous generator, VA is always less than EA Which of the following options is correct?
A 3-phase bridge converter is given a three-phase supply in the phase sequence R-Y-B. Let the neutral to R phase voltage be Vm sinωt. The first SCR (connected to R phase) is fired at an angle of 15°. What is the maximum value at the output terminals at this instant?
Which of the following instances can be held to be final orders?
1. An order of a High Court dismissing an appeal for the appellant's failure to furnish order
2. An order that an appeal had abated
3. An order in a revision reversing the dismissal of a suit and restoring it to the file of the lower court when such an order had the effect of reinstating a primary decree
4. An order refusing an application under section 45 of the Specific Relief Act 1 of 1877
5. An order passed by a High Court in insolvency proceedings