Related Questions

Tina observed the following when she tested the specific gravity of milk to check for adulteration- the specific gravity was lesser than that of pure milk. She complained to the milk vendor and the next day checked the specific gravity again. This time it came in the range of the desired specific gravity. Can we be assured that this is pure unadulterated milk?
The figure below shows the cumulative size distribution of particles of a crushed mineral. 10 kg of this material is first passed through a sieve of size 400 micron and then through a sieve of size 300 micron. The weight of mineral (in kg ) that is retained on the 300 micron sieve is . . . . . . . .
Mineral Dressing in Metallurgy mcq question image
A bed of spherical particles (specific gravity 2.5) of uniform size 1500 μm is 0.5 m in diameter and 0.5 m high. In packed bed state, the porosity may be taken as 0.4. Ergun's equation for the above fluid-particle system (in SI units) is given below:
Δ P/L = 375 × 103 VOM + 10.94 × 106 V2OM (SI units)
If water is to be used as the fluidising medium, in actual operation, the above bed has a height = 1 m. What is the porosity of the fluidised bed?
What is the average specific gravity(δav) if the specific gravity of the fuel (δf) is 0.792, the specific gravity of the oxidizer is (δo) is 1.02 and the mixture ratio (r) is 4?
A solution of specific gravity 1 consists of 35% A by weight and the remaining B. If the specific gravity of A is 0.7, the specific gravity of Bis
The figure below shows a schematic of a water droplet placed on the surfaces of two mineral P and Q.
Mineral Dressing in Metallurgy mcq question image
Given this information, pick the correct statement from the following:
Determine the density specific impulse (Id) if the specific impulse is 315 s and the average density of the propellants is 840 kg/m3. Take the reference density to be the maximum density of water.
If the Density porosity > Neutron porosity then it indicates Gas Bearing formation.
Given steps in procedure to find the center of gravity of the quadrilateral ABCD. Arrange the steps. i. Draw lines joining G1 with G2 and G3 with G4. ii. In given quadrilateral draw diagonal BD and locate centers of gravity G1, G2 of triangles BCD and ABD. iii. The point of intersection of lines G1G2 and G3G4 gives the center of gravity of the quadrilateral ABCD. iv. Similarly draw the diagonal AC and determine the centers of gravity G3, G4 of triangles ABC and ADC.
An insulating refractory brick should have high porosity and low thermal conductivity. Which of the following is not used for inducing porosity in the insulating refractory bricks during its manufacture?