Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

S1: Instantly the full load yanked Gordy towards the side of the bridge.
P: But the pull of the cable was too much.
Q: He could hardly feel the cable, slipping through his fingers, ripping off his gloves, and streaking over the railing like an escaping snake.
R: It smashed his hands hard against the top of the railing, causing a split - second feeling of fierce pain followed by numbness.
S: He held on to the cable; it had been hard work lifting it, and he did not want to have to start over again.
S6: Feeling a sharp burning sensation where the cable was speeding between his things, Gordy rose on tiptoe and as he did, the slithering coil of cable tightened around his left foot and yanked him over the railing.

The Proper sequence should be:
A network administrator is connecting hosts A and B directly through their Ethernet interfaces, as shown in the illustration. Ping attempts between the hosts are unsuccessful. What can be done to provide connectivity between the hosts?

Subnetting mcq question image

1. A crossover cable should be used in place of the straight-through cable.
2. A rollover cable should be used in place of the straight-through cable.
3. The subnet masks should be set to 255.255.255.192.
4. A default gateway needs to be set on each host.
5. The subnet masks should be set to 255.255.255.0.
Which of the following statements are true? a. In overhead lines, inductance is more predominant whereas capacitance is in the cable. b. In overhead lines, capacitance is more predominant whereas inductance is in the cable. c. Cost of cable is high compared to the overhead lines. d. Cost of cable is low compared to overhead lines
A certain cable has an insulation of relative permittivity 4. If the insulation is replaced by one of relative permittivity 2, the capacitance of the cable will become
You are setting up a network in a school. You need to network 5 computers for the file and printer sharing. You want to use some donated cable and Ethernet adapters. You identify the donated adapters as ARCnet coaxial network adapters and 10Base2 Ethernet network adapters. You install an Ethernet adapter in each of the 5 computers and connect the donated cable. The computers are NOT able to maintain reliable communication. You suspect that you are NOT using the correct type of coaxial cable. Which type of coaxial cable should you be using?
The resistance of the insulation used for the cables is 40 ohms for a length of ‘x’ km. If the proposed plan needs to extend the transmission line cable to extra ‘2x’ m then the resistance of the cable offered will be _____________ (in ohms).
Which of the following has to be considered for overhead/underground electrical power transmission / distribution system? a) The voltage at the consumer’s premises must be maintained within ± 4 or ± 6% of the declared voltage. b) The transmission cost should be unduly excessive. c) The insulation resistance of the whole system should be very high d) The loss of power in the system itself should be a small percentage (about 10%) of the power transmitted.
You have been given the task of installing cables for an Ethernet network in your office. The building is an older one, and-you have limited work space. In addition, the network cable will have to share the existing conduit with telephone cable, and cable segments will be up to 135 meters in length. Which cable is best suited to this installation?
Consider the following properties regarding insulation for cables: 1. A low specific resistance 2. High temperature withstand 3. High dielectric strength Which of the above properties of insulation are correct while using cables?
If a cable of homogeneous insulation has a maximum stress of 10 kV/mm, then the dielectric strength of insulation should be