Bissoy.com
Doctors Medicines MCQs Q&A

The following are the reasons for hard steering
1. Excessive castor may be there
2. Incorrect wheel alignment
3. Tyre pressure may be too high
4. Steering-gear may be adjusted too tightly

The following are the reasons for hard steering
1. Excessive castor may be there
2. Incorrect wheel alignment
3. Tyre pressure may be too high
4. Steering-gear may be adjusted too tightly Correct Answer 1, 2 & 4 are correct

Related Questions

A car tyre of volume 0.057 m3 is inflated to 300 kPa at 300 K. After the car is driven for 10 hours, the pressure in the tyre increases to 330 kPa. Assume air is an ideal gas and Cv for air is 21 J/mole.K. The change in the internal energy of air in the tyre in J/mole is
The circumference of the back-sided wheel of a vehicle is 1 m greater than that of front side wheel. To travel 600 m, the front wheel rotates 30 times more than the back wheel. The circumference of the front wheel is :
Consider the following countries with respect to the production of castor oil seeds in the world.  I. Mozambique  II. China  III. India  Which among the following is the correct sequence of the countries with respect to the production of castor oil seeds, starting from the largest producer from the left?
In the following question below are given some statements followed by some conclusions base on those statements. Taking the given statements to be true even if they seem to be at variance from commonly known facts. Read all the conclusions and then decide which of the given conclusion logically follows the given statements. Statements: I. No cycle is handle. II. Some handle are tyre. Conclusions: I. No tyre is cycle. II. Some tyre are handle. III. Some cycle are handle.
In this question, a statement is given followed by four conclusions. Choose the conclusion(s) which best fit(s) logically. Statement: To pass the examination, one must work hard. Conclusions: I. Examination is related to only hard work. II. All those who do not work hard pass. III. Without hard work, one does not pass. IV. Hard-working person is a satisfied person.
Water, having a density of 1000 kg/m3, leave from a nozzle with a velocity of 10 m/s and the jet strikes a bucket mounted on a Pelton wheel. The wheel rotates at 10 rad/s. The mean diameter of the wheel is 1 m. The jet is split into two equal streams by the bucket, such that each stream is deflected by 120°, as shown in the figure. Friction in the bucket may be neglected. Magnitude of the torque exerted by the water on the wheel, per unit mass flow rate of the incoming jet, is
For wheel and tyre troubles the cause of one side wear of tyre is
For wheel and tyre trouble the cause of Uneven tyre wear is-
A circular wheel 28 inches in diameter rotates the same number of inches per second as a circular wheel 35 inches in diameter. If the smaller wheel makes x revolutions per second, how many revolutions per minutes does the larger wheel make in terms of x?
A wheel that has 6 cogs is meshed with a wheel of 14 cogs. When the smaller wheel has made 21 revolutions the number of revelution made by the larger wheel is --