Related Questions

An engine pulls four identical carriages. The engine is 2/3 the length of a carriage and the total length of the train is 86.8m. Find the length of the engine.
A 12.4m
B 12m
C 11.5m
D 13m
A two stroke cycle engine gives ________ the number of power strokes as compared to the four stroke cycle engine, at the same engine speed.
A Half
B Same
C Double
D Four times
If the engine coolant leaks into the engine oil, then engine oil
A Appears milky
B Become foamy
C Turns black
D None of these
Fill in the gap : The first engine ----heat to drive a machine was the steam engine.
A made use of
B to make use of
C of using
D of making use
How are the efficiencies of any heat engine (miu) and reversible heat engine (miuR) compared, when both are operating between same heat source and same heat sink?
A miu = miuR
B miu>miuR
C miu
D none of these
একটি কর্নো ইঞ্জিন 500 K এবং 205 K তাপমাত্রার দুইটি আধারের মাধ্যমে পরিচালিত হয়। প্রত্যেক চক্রে ইঞ্জিন যদি উৎস থেকে 1 kcal তাপ গ্রহণ করে তাহলে প্রত্যেক চক্রে তাপ গ্রাহকে তাপ বর্জন করার পরিমাণ কত? ( A Carnot engine is operated between two reservoirs at temperatures of 500 K and 250K. If the engine receives 1 kcal of heat from the source in each cycle, the amount of heat rejected to the sink in each cycle is-)
A 500 cal
B 1000 cal
C 500 kcal
D 10 kcal
একটি কার্নো ইঞ্জিন 500K এবং 250K তাপমাত্রার দুইটি আধারের মাধ্যমে পরিচালিত হয়। প্রত্যেক চক্রে ইঞ্জিন যদি উৎস থেকে । kcal তাপ গ্রহণ করে তাহলে প্রত্যেক চক্রে তাপ গ্রাহকে তাপ বর্জন করার পরিমাণ কত? ( A Carnot engine is operated between two reservoirs at temperatures of 500 K and 250 K. If the engine receives 1 kcal of heat from the source in cach cycle, the amount of heat rejected to the sink in each cycle is --)
A 500 cal
B 1000 cal
C 500 kcal
D 10 kcal
When the load on the engine increases, it becomes necessary to increase the supply of working fluid and when the load decreases, less working fluid is required. The supply of the working fluid to the engine is controlled by a
A D-slide valve
B governor
C Meyer’s expansion valve
D flywheel
Which of the following is used to control the speed variations of the engine caused by the fluctuations of the engine turning moment?
A D-slide valve
B Governor
C Flywheel
D Meyer’s expansion valve
In a four stroke cycle petrol engine, the pressure inside the engine cylinder during the suction stroke is __________ the atmospheric pressure.
A equal to
B below
C above
D middle

Next steps