Related Questions

While the thermosetting polymers are amorphous in nature, the thermoplastic polymers are either amorphous or crystalline. The crystalline polymers are characterised by the
A Low impact strength
B High flexibility
C Better finish and surface appearance
D High plastic deformation
You are the network administrator for your company. Mike Nash is a member of the Administration group, and Nate Sun is a member of the Intern group. Both groups are in the same domain. On the intranet server, the Administration group is placed in the Security group, and the Intern group is placed in the Nonsecurity group. The Security group is then granted Full Control permission for the Sales virtual directory. Nate needs to update new sales information that is located on the Sales virtual directory. What should you do so that Nate can perform this task?
A Enable Anonymous access for the intranet server
B Enable Anonymous access for the Sales virtual directory
C Remove Nate fmm the Intern group
D Make Nate a member of the Security group
E None of above
Dacron (or terylene) fibres as compared to nylon fibres have
A Better heat & acid resistant properties
B Poorer resistance to alkalis
C Poorer dyeability
D All of the above
Dacron (or terylene) fibres as compared to nylon's fibres have
A Better heat & acid resistant properties
B Poorer resistance to alkalis
C Poorer dyeability
D All of the above
Melt spinning of polymers involves the forcing of polymer melt through spinnerettes (fine holes) into an atmosphere kept at a temperature lower than the melting point of the polymer, which causes the fine diameter polymer melt to harden into filaments. Melt spinning is not used in case of the __________ fibres.
A Acrylic
B Polyester
C Nylon 6:6
D Polypropylene
In case of wet spinning of polymers, the polymer solution is forced through spinnerates into, a coagulating bath to give a filament form. Wet spinning is not used in case of the __________ fibres.
A Viscose rayon
B Acrylic
C Polyvinyl acetate
D Saturated polyester
In case of dry spinning of polymers, the polymer solution in a volatile solvent is forced through the spinnerates into a warm air chamber, where the solvent evaporates leaving behind the polymer in the filament form. Dry spinning is used for __________ fibres.
A Polythene
B PVC
C Rayon
D Polyvinyl acetate
Thermosetting polymers as compared to thermoplastic polymers
A Are formed by addition polymerisation
B Have three dimensional structure
C Have linear structure
D None of these
Branched chair polymers as compared to linear polymers have
A Higher melting point
B Higher tensile strength
C Lower density
D None of these
In a linear polymer, the monomeric units are linked together to form long straight chains. The cross linked or branched chain polymers compared to linear polymers have higher
A Densities
B Melting point
C Tensile strength
D Hardness, rigidity & brittleness

Next steps