Related Questions

Cartridge brass can be
A Cold rolled into sheets
B Drawn into wires
C Formed into tube
D Any one of these
If the length of a edge of cube X is thrice the length of an edge of cube Y, What is the ration of the volume of cube Y to the volume of cube X?
A 1/2
B 1/4
C 1/6
D 1/8
In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to
A 1 d
B 1.25 d
C 1.5 d
D 1.75 d
To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to
A 0.5 d
B D
C 1.5 d
D 2.5 d
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)
A 1 d
B 1.5 d
C 2.5 d
D 2 d
In order to avoid tearing off the plate at an edge, the distance from the center of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)
A d
B 1.5 d
C 2 d
D 2.5 d
The materials which fracture even at small strains are termed as brittle, while those materials which exhibit an appreciable deformation before failure are termed as
A Rigid
B Tough
C Ductile
D Plastic
Some traditional board drafters preferred the drafting machine over the parallel straight edge because it could be used without the need for _________.
A Circle templates
B Triangles
C Technical pens
D Lettering guides
A considerable part of the harmful ultraviolet radiation of the sum does not reach the earth surface, because of the fact that, there is a layer of __________ high above earth's atmosphere, which absorbs it.
A Hydrogen
B Carbon dioxide
C Ozone
D None of these
The cracks in helical springs used in railway carriages usually start on the inner side of the coil because of the fact that
A It is subjected to a higher cyclic loading than the outer side
B It is subjected to a higher stress than the outer side
C It is more stretched than the outer side during the manufacturing process
D It has a lower curvature than the outer side

Next steps