Related Questions

The forces causing the vaporisation of liquid are derived from the Kinetic energy of translation of its molecules. The heat of vaporisation
A Increases with pressure rise
B Decreases with increasing pressure
C Becomes zero at the critical point
D Both B & C
At normal boiling point, molar entropy of vaporisation is __________ Joule/K°.mole.
A 72
B 92
C 142
D 192
In case of __________ boiling, the liquid temperature is below the saturation temperature and the boiling takes place in the vicinity of the heated surface.
A Nucleate
B Local
C Pool
D Saturated
The distillation carried out in such a way that the liquid with the lowest boiling point is first evaporated and re-condensed, then the liquid with the next higher boiling point is then evaporated and re-condensed, and so on until all the available liquid fuels are separately recovered in the sequence of their boiling points. Such a process is called
A Cracking
B Fractional distillation
C Full distillation
D Carbonisation
When vaporisation takes place directly at the heating surface, it is called
A Film boiling
B Nucleate boiling
C Vapour binding
D None of these
In convection heat transfer from hot flue gases to water tube, even though flow may be turbulent, a laminar flow region (boundary layer of film) exists close to the tube. The heat transfer through this film takes place by
A Convection
B Radiation
C Conduction
D Both convection and conduction
Overall mass transfer co-efficient in case of absorption of __________ in water is based on the gas film co-efficient only, as the mass transfer process is gas film (phase) controlling.
A CO2
B SO2
C NH3
D None of these
The temperature at which a gas, when subjected to Joule-Thomson expansion, neither cools or heats up, is termed as the __________ temperature. Above this temperature the gas heats up on throttling and below this the gas cools down.
A Isotactic
B Saturation
C Inversion
D Throttling
Specific __________ does not change during a phase change (e.g. sublimation, melting, vaporisation etc.).
A Entropy
B Internal energy
C Enthalpy
D Gibbs free energy
Humidity chart is useful for the solution of problems concerning condensation, vaporisation and air conditioning. At a given dry bulb temperature, value of humidity obtained from the humidity chart directly, is in terms of __________ humidity.
A Molal
B Relative
C Percentage
D None of these

Next steps