Related Questions

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires
A Less heating surface
B More space
C Lower maintenance cost
D None of these
LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is
A 0
B 1
C >1
LMTD in case of counter flow heat exchanger as compared to parallel flow heat exchanger is
A Higher
B Lower
C Same
D Depends on the area of heat exchanger
If all the conditions and dimensions are same, then the ratio of velocity through the tubes of a double pass heat exchanger to that through the single pass heat exchanger is
A 1
B 2
C $$\frac{1}{2}$$
D 4
In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.
A Once
B Twice
C Thrice
D Four times
In counter current flow heat exchanger, the logarithmic temperature difference between the fluids is ________ as compared to parallel flow heat exchanger.
A Same
B Less
C Greater
D None of these
__________ heat exchanger is also known as 'hair pin type' exchanger,
A Double pipe
B Finned
C Plate type
D Regenerative
Gold is 19 times as heavy as water and Copper is 9 times as heavy as water. Calculate the ratio in which these two metals should be mixed so that the mixture is 15 times as heavy as water.
A 40
B 41
C 42
D 43
For large heat transfer area requirement, shell and tube heat exchanger is preferred, because it
A Occupies smaller space
B Is more economical
C Is easy to operate and maintain
D All of the above

Next steps