Related Questions

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.
A Once
B Twice
C Thrice
D Four times
In a shell and tube heat exchanger, the tube side heat transfer co-efficient just at the entrance of the tube is
A Infinity
B Zero
C Same as average heat transfer co-efficient for tube side
D None of these
For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it
A Decreases the pressure drop
B Decreases the outlet temperature of cooling medium
C Increases the overall heat transfer coefficient
D None of these
For shell and tube heat exchanger, with increasing heat transfer area, the purchased cost per unit heat transfer area
A Increases
B Decreases
C Remains constant
D Passes through a maxima
Extremely large or small volumes of fluids are generally best routed through the shell side of a shell and tube heat exchanger, because of the
A Less corrosion problems
B Flexibility possible in the baffle arrangement
C Low pressure drop
D High heat transfer co-efficient
In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of __________ mm.
A 3-5
B 5-11
C 8-15
D 12-18
In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate.
A Increases
B Decreases
C Does not affect
D May increase or decrease, depends on the type of baffle
A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires
A Less heating surface
B More space
C Lower maintenance cost
D None of these
In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is taken care of by using a
A U-bend
B Floating head tube sheet
C Either A or B
D Neither A nor B

Next steps