Related Questions

A simple three-phase generator consists of three conductive loops separated by 120°.
Four main subtypes of secondary structures can be identified. They are hairpin loops, bulge loops, interior loops, and multi-branch loops.
An a.c. generator consists of a coil of 50 turns and an area 2.5 m2 rotating at an angular speed of 60 rad s-1 in a uniform magnetic field of 0.3 T between two fixed pole pieces. What is the flux through the coil, when the current is zero?
A piece of paraffin is placed in a uniform magnetic field H0. The sample contains hydrogen nuclei of mass mp, which interact only with external magnetic field. An additional oscillating magnetic field is applied to observe resonance absorption. If g1 is the g-factor of the hydrogen nucleus, the frequency at which resonance absorption takes place, is given by
Which of the following statements are correct?
1. Change in magnetic field produces induced current.
2. Flow of current in a conductor produces magnetic field.
3. Magnetic field related to coil can be produced by motion between conductor and coil.
In a turbopump system using a gas generator cycle, the flame temperature in the separate gas generator where a small portion of overall propellant is burned is _________ compared to the main gas generator and its mixture ratio is _________ compared to that of the main gas generator.
The conductive loop on the rotor of a simple two-pole, single-phase generator rotates at a rate of 400 rps. The frequency of the induced output voltage is
If the magnetic meridian of a certain place, the horizontal component of the earth’s magnetic field is 0.26 G and the dip angle is 60°, what is the magnetic field of earth at this location?
The length of a rectangular field F is 3 km greater than the side of a square field M , and the width of field F is 3 km less then the side of field M. If the area of field M is m2 square km, what is the area of field F?
A 100KW, 250 V, 400 A, a long shunt compound generator has an armature resistance of 0.025 ohms. There are 1000 shunt fields turns per pole and 3 series field turns per pole. The series field is connected in a such a fashion that positive armature current produces direct-axis MMF which adds to that of the shunt field. Compute the gross MMF at the rated terminal current when shunt field current is 4.7A and speed is 1150 rpm.