Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the circuit shown below which reduces the impact of the input bias current. If IB1 = IB2 = Input bias current, then determine the value of R3 so that the output voltage (v0) is not impacted by the input bias current.
Consider an inverting amplifier circuit designed using an op amp and two resistors, R1 = 10 kΩ and R2 = 1 MΩ. If the op amp is specified to have an input bias current of 100 nA and an input offset current of 10 nA, find the output dc offset voltage resulting.
Which factor affect the input offset voltage, bias current and input offset current in an op-amp
Consider the following statements in the relevant context: 1. The two types of currents that flow in semiconductor diodes and transistors are drift and diffusion currents. 2. The junction region is called depletion region or space-charge region. 3. When currents flow through the diode in forward bias, the depletion region current is mostly of ‘diffusion’ type. Which of the above statements are correct?
Assertion (A): All the mesh currents are necessarily the loop currents but all the loop currents may not be the mesh current. Reason (R): The mesh current is the current which flows only around the perimeter of a mesh.
Which of the following statements is not true with regard to Ocean currents? (i) The warm ocean currents originate near the equator and move towards the poles. (ii) The cold currents carry water from polar or higher latitudes to tropical or lower latitudes. (iii)  The Labrador Ocean current is cold current while the Gulf Stream is a warm current.
Which of these statements are correct?
1. Ocean currents are the slow- surface movement of water in the ocean.
2. Ocean currents assist in maintaining the Earth's heat balance.
3. Ocean currents are set in motion primarily by prevailing winds.
4. Ocean currents are affected by the configuration of the ocean.
Which of the following conditions must be satisfied for a transistor to be in saturation? 1. Its collector to base junction should be under forward bias 2. Its collector to base junction should be under reverse bias 3. Its emitter to base junction should be under reverse bias 4. Its emitter to base junction should be under forward bias Which of the above conditions are correct?
If CT is the transition capacitance, which of the following are true? 1) in forward bias, CT dominates 2) in reverse bias, CT dominates 3) in forward bias, diffusion capacitance dominates 4) in reverse bias, diffusion capacitance dominates
Consider an inverting amplifier with a nominal gain of 1000 constructed from an op amp with an input offset voltage of 3 mV and with output saturation levels of ±10 V. If the effect of VOs(input offset voltage) is nulled at room temperature (250C), how large an input can one now apply if the circuit is to operate at a constant temperature?