Related Questions

When an electric current coil of a wattmeter is connected to the electric current path R and the voltage coil is connected between the electric current R path and the neutral side of the balanced three phase supply, it shows 10 kW. The line voltage along the phase sequence RYB is 400 V. The current drawn by the current path is 54 A. What is the new reading of the wattmeter if the voltage coil is connected between the lines B and the Y paths, even if the electric current coil is continuously present in the line R?
When a 1-phase transformer is connected in parallel, there are four conditions for proper parallel operation, but when two or 3-phase transformer paralleling is done, there are two additional points along with those four conditions applied for 1-phase. Statement 1 - The phase sequence must be the same. Statement 2 - The phase shift between primary and secondary voltages must be the same for all transformers connected in parallel. From the above two Statements (s), which is/are the correct conditions in this regard?
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
What is the formula of the angle between secondary induced voltage and secondary current? b) phase angle = tan-1 * c) phase angle = tan-1 * d) phase angle = tan-1 *
At series resonance, the phase angle between applied voltage and circuit is ___________
Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
What is the phase angle between the capacitor current and the applied voltage in a parallel RC circuit?
Consider the following statements regarding reciprocity theorem : 1. In any passive linear bilateral network, if the single voltage source Vx, in branch x produces the current response Iy, in branch y, then the removal of the voltage source from branch x and its insertion in branch y will produce the current response iy in branch x. 2. The interchange of an ideal voltage source and an ideal ammeter in any passive, linear, bilateral circuit will not change the ammeter reading. 3. The interchange of an ideal current source and an ideal voltmeter in any passive linear bilateral circuit will change the voltmeter reading. Which of the above statements are correct ?
Consider the following statements regarding n-channel JFET: 1. The maximum drain current IDSS occurs when gate-to-source voltage VGS = 0 V and drain-to-source voltage VDS ≥ |VP|. (VP is pinch-off voltage). 2. For gate-to-source voltage VGS less than the pinch-off level, the drain current is 0 A. 3. For all levels of VGS between 0 V and the pinch-off level, the current ID will range between IDSS and 0 A, respectively. which of the above statements are correct ?
The circuit phase angle is the angle between the total current and the applied (source) voltage.