Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements regarding JFET: 1. The relationship between the drain current and gate-to-source voltage of a JFET is a nonlinear. 2. The minimum current for JFET occurs at pinch-off voltage defined by VGS = VP. 3. A current controlled device is one in which a current defines the operating conditions of the device. Which of the above statements are correct?
A p-channel Ge JFET has max-half channel width 5µm and channel conductivity of 2/Ωcm, if Er = 2000cm2/Vsec, What is the value of pinch off voltage?
Statement (I): An alluvial channel is defined as a channel in which the flow transports sediment of the same physical characteristic as the material in the wetted surface of the channel. Statement (II): This ensures that the channel cross-section and the channel slope do not change.
The Secure Shell Connection Protocol Message exchange has the fist phase as “Opening a Channel” and it sends a message with parameters- SSH_MSG_CHANNEL_OPEN channel type sender channel innitial window size maximum packet size What is the data type sender channel/innitial window size/ channel type?
Assertion (A): A JFET can be used as a current source.Reason (R): In beyond pinch off region the current in JFET is nearly constant.
Assertion (A): A JFET can be used as a current source.
Reason (R): In beyond pinch off region the current in JFET is nearly constant.
If the cross-sectional area of the channel in n-channel JFET increases, the drain current__________
The Transfer characteristic of the different types of MOSFETs is shown below, where ID is drain current and VGS is the Gate-Source voltage, the correct combination of MOSFET w.r.t to transfer characteristics is: Types of MOSFET (P) P – Channel Enhancement MOSFET (Q) P – Channel Depletion MOSFET (R) N – Channel Enhancement MOSFET (S) N – Channel Depletion MOSFET
The discharge through a trapezoidal channel is 61 m3/s and the depth and widths of the channel are 4m and 5m respectively. The wetted perimeter of the channel is 13.16m, calculate the bed slope of the channel if the value of C is 45.
Calculate the corresponding hydraulic mean depth that would exist in the channel if the bed was unrippled. The rugosity coefficient in an unrippled channel is 0.015 and the rugosity coefficient actually observed by experiments on the rippled bed of channel is 0.020. Consider the value of hydraulic mean depth of the channel as 1.5 m.