Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The Transfer characteristic of the different types of MOSFETs is shown below, where ID is drain current and VGS is the Gate-Source voltage, the correct combination of MOSFET w.r.t to transfer characteristics is: Types of MOSFET (P) P – Channel Enhancement MOSFET (Q) P – Channel Depletion MOSFET (R) N – Channel Enhancement MOSFET (S) N – Channel Depletion MOSFET
Choose the correct statement(s) i) The gate circuit impedance of MOSFET is higher than that of a BJT ii) The gate circuit impedance of MOSFET is lower than that of a BJT iii) The MOSFET has higher switching losses than that of a BJT iv) The MOSFET has lower switching losses than that of a BJT
In the following figure, the transmitter Tx sends a wideband modulated RF signal via a coaxial cable to the receiver Rx. The output impedance ZT of Tx, the characteristic impedance Z0 of the cable, and the input impedance ZR of Rx are all real. Which one of the following statements is TRUE about the distortion of the received signal due to impedance mismatch?
After conjugate impedance matching the input impedance used for matching after normalization was 1+j with the characteristic impedance of the transmission line being 100Ω, then the generator impedance must have been:
A word arrangement machine, When given an input line of words, rearranges it in every step following a certain rule. Following is an illustration of an input line of words and various steps of rearrangement.
Input: gone are take enough brought station
Step 1: take gone are enough brought station
Step 2: take are gone enough brought station
Step 3: take are station gone enough brought
Step 4: take are station brought gone enough
And Step 4 is the last step for this input. Now, find out an appropriate step in the following question following the above rule. Question:
Input: car on star quick demand fat
What will be the third step for this input ?
An electronic device when fed with the numbers, rearranges them in a particular order following certain rules. The following is a step-by-step process of rearrangement for the given input of numbers. Input :- 85 16 36 04 19 97 63 09 Step I :- 97 85 16 36 04 19 63 09 Step II :- 97 85 63 16 36 04 19 09 Step III :- 97 85 63 36 16 04 19 09 Step IV :- 97 85 63 36 19 16 04 09 Step V :- 97 85 63 36 19 16 09 04 (for the given input step V is the last step). Which of the following will be the last step for the given input ? Input :- 03 31 43 22 11 09
Expression for input impedance of a transmission line in terms of load impedance and characteristic impedance is:
For a lossy transmission line, γ=0.02+j0.15 and is 20m long. The line is terminated with an impedance of a 400Ω. Then the input impedance of the transmission line given that the characteristic impedance of the transmission line is 156.13+j11.38Ω is:
Find the load impedance in a quarter line transformer with characteristic impedance of 75 ohm and input impedance of 200 ohm.
In the below input output characteristic of MOSFET amplifier, if Vin > Vin1, the MOSFET is said to operate in: