Related Questions

Steam turbines commonly used in steam power station are
A condensing type
B non-condensing type
C both (A) and (B)
D none of the above
In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.
A Equal to
B Less than
C More than
D None of these
In a steam engine, superheated steam from the boiler is fed into the steam chest at a pressure of
A 10 atmospheres
B 20 atmospheres
C 30 atmospheres
D 40 atmospheres
A steam turbine, in which a part of the steam after partial expansion, is used for process heating and the remaining steam is further expanded for power generation, is known as
A Back pressure turbine
B Pass out turbine
C Low pressure turbine
D Impulse turbine
A survey was conducted among the students of Khulna University to find out how many forms of physical exercise usually swam, 25% said they usually did jogging, 20% said they played cricket, 15% said they usually played football and 20 respondents said they did not take any form of exercise. From the above findings it can be concluded that.
A The student of khulna University do not usually take physical exercise.
B No respondent took more than one form of exercise.
C The method of data collection was not valid.
D Some of the respondents took more than one form of exercise.
In case of non-condensing steam engines, the pressure of steam in the cylinder during exhaust stroke is _________ the condenser pressure.
A Equal to
B Lower than
C Higher than
D None of these
The ratio of exit pressure to inlet pressure of maximum mass flow rate per area of steam through a nozzle when steam is initially superheated is
A 0.555
B 0.578
C 0.5457
D 0.6
The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is
A 0.6
B 0.578
C 0.555
D 0.5457
In case of condensing steam engines, the pressure of steam in the cylinder during exhaust stroke is _________ the atmospheric pressure.
A Equal to
B Lower than
C Higher than
D None of these
In a steam engine, one method of obtaining the earlier cut-off with a simple slide valve is by increasing the angle of advance of the eccentric while the throw of the eccentric, steam lap and exhaust lap are kept constant. This method will
A Cause withdrawing or throttling of steam
B Reduce length of effective stroke of piston
C Reduce maximum opening of port to steam
D All of these

Next steps