Related Questions

The shear force at the center of a simply supported beam with a gradually varying load from zero at both ends to w per meter at the center, is
A Zero
B $$\frac{{{\text{w}}l}}{4}$$
C $$\frac{{{\text{w}}l}}{2}$$
D $$\frac{{{\text{w}}{l^2}}}{2}$$
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm
A single phase transformer has a maximum efficiency of 90% at full load and unity power factor. Efficiency at half load at the same power factor is -
A 87.8%
B 86.7%
C 88.26%
D 88.9%
ABCD is a square of side 10. AFC is an are of a circle with the center at D and radius 10. AGC is an are of a circle with the center at B and radius 10. Find the area of AFCG/
A 50 -100pie
B 25 -100 pie
C 100-25 pie
D 100-50pie
Radius of circle center 0 is 3 times the radius of circle center C. Angle ACB -A angle POQ. If the shaded are of circle C is 2 then what is the area of then shaded part of circleO?
A 36
B 9
C 12
D 18
ABCD is a square of side 8 AFC is an are of a cricle with the center at D and radius 8 . AGC is an are of a circle with the center at B and radius 8. Find the area of AFCG.
A 32 pie -32
B 64 pie-64
C 64-32pie
D 32 pie - 64
Two circular dials of exactly the same size are mounted on a wall side by side in such a way that their perimeters touch at one point. Dial 1, which is on the left , spins clockwise around its center , and dial 2 , which is on the right spins counter clockwise around its center . (Assume that there is no friction at the point of contact between the dials.) Each dial is marked on its perimeter at three points that are at equale distances around the points arked ondial 1 are N, O, and P and the points marked on dial 2 are X, Y, and Z. If points O and Z are just meeting at the point of contact between the dials , and if dial 1 spins at the same speed as dial 2, what is the smallest number of revolutions of each dial that will bring O and Z together again?
A 1
B 2
C 3
D 4
The center to center distance, between two consecutive rivets in a row, is called
A Margin
B Pitch
C Back pitch
D Diagonal pitch
A circle passing through the pitch point with its center at the center of cam axis is known as
A Pitch circle
B Base circle
C Prime circle
D Outer circle

Next steps