Related Questions

One of the major----load shedding.
A problems are
B problems is
C problem be
D problem is
Load shedding is possible through which of the following ?
A Switching of the loads
B Frequency reduction
C Voltage reduction
D Any of the above
Last year, one of the major _load shedding.
A problems is
B problem was
C problems was
D problems has been
For a snake, shedding their skin up to eight times a year is part of a natural process.
A For a snake, shedding their skin
B A snake's shedding its skin
C When a snake sheds its skin
D to shed its skin, for
He couldn't but help shedding tears at the plight of the villagers rendered homeless by a devastating cyclone.
A he couldn't but help
B shedding tears at the plight of the villagers
C rendered homeless by a devastating cyclone
D no error
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm
The load factors for live load and dead load are taken respectively as
A 1.5 and 2.2
B 2.2 and 1.5
C 1.5 and 1.5
D 2.2 and 2.2
The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is
A $$\frac{5}{8}$$
B $$\frac{8}{5}$$
C $$\frac{5}{4}$$
D $$\frac{4}{5}$$
When the load on the engine increases, it becomes necessary to increase the supply of working fluid and when the load decreases, less working fluid is required. The supply of the working fluid to the engine is controlled by a
A D-slide valve
B governor
C Meyer’s expansion valve
D flywheel

Next steps