Related Questions

As hysteresis motors are free from mechanical and magnetic vibrations therefore these are considered as suitable for
A fans
B blowers
C sound equipment
D mixer grinders
The frequency of damped vibrations with viscous damping is ________ the frequency of undamped vibrations.
A More than
B Less than
C Same as
D None of these
In steady state forced vibrations, the amplitude of vibrations at resonance is __________ damping coefficient.
A Equal to
B Directly proportional to
C Inversely proportional to
D Independent of
The degree of mechanical vibrations produced by the laminations of a transformer depends on
A tightness of clamping
B gauge of laminations
C size of laminations
D all of the above
The noise resulting from vibrations of laminations set by magnetic forces, is termed as
A Magnetostriction
B Boo
C Hum
D Zoom
Of the 120 households in an area, 55 have cars, 35 have motor bikes, and 20 have both cars and motor bikes. How many of the households in the area have neither cares nor motor bikes?
A 110
B 90
C 50
D 30
The natural frequency of free torsional vibrations of a shaft is equal to (where q = Torsional stiffness of the shaft and $$I$$ = Mass moment of inertia of the disc attached at the end of a shaft)
A $$2\pi \sqrt {\frac{{\text{q}}}{I}} $$
B $$2\pi \sqrt {{\text{q}}I} $$
C $$\frac{1}{{2\pi }}\sqrt {\frac{{\text{q}}}{I}} $$
D $$\frac{1}{{2\pi }}$$
The natural frequency of free longitudinal vibrations is equal to (where m = Mass of the body, s = Stiffness of the body and $$\delta $$ = Static deflection of the body)
A $$\frac{1}{{2\pi }} \times \sqrt {\frac{{\text{s}}}{{\text{m}}}} $$
B $$\frac{1}{{2\pi }} \times \sqrt {\frac{{\text{g}}}{\delta }} $$
C $$\frac{{0.4985}}{{\sqrt \delta }}$$
D Any one of these
One D.C. motor drives another D.C. motor. The second D.C. motor when excited and driven
A Runs as a generator
B Does not run as a generator
C Also runs as a motor comes to stop after sometime
D None of these
The natural frequency of free transverse vibrations due to uniformly distributed load acting over a simply supported shaft is (where $$\delta {\text{S}}$$ = Static deflection of simply supported shaft due to uniformly distributed load)
A $$\frac{{0.4985}}{{\sqrt {\delta {\text{S}}} }}$$
B $$\frac{{0.5615}}{{\sqrt {\delta {\text{S}}} }}$$
C $$\frac{{0.571}}{{\sqrt {\delta {\text{S}}} }}$$
D $$\frac{{0.6253}}{{\sqrt {\delta {\text{S}}} }}$$

Next steps