Related Questions

When a capacitor was connected to the terminal of ohmmeter, the pointer indicated a low resistance initially and then slowly came to infinity position. This shows that capacitor is
A Short-circuited
B All right
C Faulty
D None of the above
If an ohmmeter reading immediately goes practically to zero and stays there, capacitor is
A Charged
B Short-circuited
C Lossy
D Satisfactory
While testing a capacitor with ohm meter, if the capacitor shows charging, but the final resistance reading is appreciably less than normal, it can be concluded that the capacitor is
A Short-circuited
B Open circuited
C Alright
D Leaky
If the capacitor of a single-phase motor is short-circuited
A the motor will not start
B the motor will run
C the motor will run in reverse direction
D the motor will run in the same direction at reduced r.p.m.
If the input capacitor of a transistor amplifier is short-circuited, then
A Transistor will be destroyed
B Biasing conditions will change
C Signal will not reach the base
D None of the above
While conducting short-circuit test on a transformer the following side is short circuited
A High voltage side
B Low voltage side
C Primary side
D Secondary side
When using ohmmeter, applied voltage is to be disconnected from the circuit because
A Voltage source will increase resistance
B Current will decrease resistance
C The ohmmeter has its own internal battery
D None of the above
An ohmmeter is a
A moving iron instrument
B moving coil instrument
C dynamometer instrument
D none of the above
An open resistor, when checked with an ohmmeter reads
A Zero
B Infinite
C High but within tolerance
D Low but not zero
An ohmmeter is connected across an inductor and the pointer indicates zero ohms. The inductor is
A Good
B Open
C Shorted
D Partly shorted

Next steps