Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

You use Microsoft Visual Studio 2010 and Microsoft .NET Framework 4 to create anapplication. The application uses the ADO.NET Entity Framework to model entities. Theapplication allows users to make changes to entities while disconnected from the central data store. You need to ensure that when the user connects to the central data store and retrieves new data, the application meets the following requirements:
  • Changes made to the local data store in disconnected mode are preserved.
  • Entities that have already been loaded into the local data store, but have not been modified by the user, are updated with the latest data.
What should you do?
Transients are caused because 1. The load is suddenly connected to or disconnected from the supply 2. of the sudden change in applied voltage from one finite value to the other 3. of the change in stored energy in inductors and capacitors Which of the above statements are correct
Consider the following statements: 1. The voltage developed across the OFF switches of the half-bridge converter is the maximum dc-link voltage. 2. In the full-bridge converter, the voltage across the primary of the transformer is the dc link voltage. 3. The voltage developed across the OFF switches of the full-bridge converter is half the maximum dc-link voltage. Which of the above statements are correct?
In comparing the operation of the half-controlled 2-pulse circuit with that of the fully-controlled circuit, which of the following statements are evident? 1. Since half the thyristors are replaced by diodes, a half-controlled converter costs less than a fully-controlled converter. 2. Due to the freewheeling action with a half-controlled bridge-circuit power factor is improved in half-controlled converters. 3. The AC supply current is more distorted due to its zero periods with the half-controlled circuit, compared to a fully-controlled bridge circuit. Select the correct answer using the code given below :
What are the steps required in sequence to solve a circuit using superposition theorem? (a) Select any one source and short circuit all other voltage sources. (b) Find out the current or voltage across the required element, due to the source under consideration. (c) Open all current sources, if the internal impedance is not known. If known replace them by their impedances. (d) Add all the individual effects produced by individual sources to obtain the total current in or across the voltage element. Code :
A 50 Hz synchronous generator is initially connected to a long lossless transmission line which is open circuited at the receiving end. With the field voltage held constant, the generator is disconnected from the transmission line. Which of the following may be said about the steady state terminal voltage and field current of the generator?
A voltage v (t) = 100sinωt is applied to a circuit. The current flowing through the circuit is i(t) = 15sin(ωt-30⁰). Determine the average power delivered to the circuit.
series R-C circuit consists of resistor of 10 and capacitor of 0.1F as shown in the figure. A constant voltage of 20V is applied to the circuit at t = 0. What is the current in the circuit at t = 0?
Given the following circuit. The supply voltage being applied is ±15V. The diode cut-in voltage is 0.7V. Find the maximum value of R such that circuit can behave as a monostable multivibrator.
A voltage v (t) = 100sinωt is applied to a circuit. The current flowing through the circuit is i(t) = 15sin(ωt-30⁰). Find the effective value of voltage.