Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The parallel combination of a 6.8 kΩ resistor and a 10 kΩ resistor is in series with the parallel combination of a 2.2 kΩ resistor and a 1 kΩ resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)
Two resistors are in series: a 5.6 kΩ resistor and a 4.7 kΩ resistor. The voltage drop across the 5.6 kΩ resistor is 10 V. The voltage across the 4.7 kΩ resistor is
A certain series circuit consists of a $$\frac{1}{8}$$ W resistor, a $$\frac{1}{4}$$ W resistor and a $$\frac{1}{2}$$ W resistor. The total resistance is 1200 Ω. If each resistor is operating in the circuit at its maximum power dissipation, total current flow is
The input voltage V1 of the circuit the circuit is 2V and resistor has a resistance of 1KΩ. The cut-in voltage of the silicon diode is 0.7V and the reverse saturation current is 10-8A. The temperature at which diode operates is 30°C. The voltage across resistor when diode starts conducting is _________________
A series resonant band-pass filter consists of a 2 mH coil, a 0.005 µF capacitor and a 120 Ω resistor. The winding resistance of the coil is 12 Ω. The output voltage is taken off the resistor. Input voltage is 12 Vrms. What is the output voltage magnitude at the center frequency (f0)?
A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately
series R-C circuit consists of resistor of 10 and capacitor of 0.1F as shown in the figure. A constant voltage of 20V is applied to the circuit at t = 0. What is the current in the circuit at t = 0?
A series resonant band-stop filter consists of a 68 Ω resistor, a 110 mH coil, and a 0.02 µF capacitor. The internal resistance, RW, of the coil is 4 Ω. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?
The parallel combination of a 470 Ω resistor and a 1.2 kΩ resistor is in series with the parallel combination of three 3 kΩ resistors. A 200 V source is connected across the circuit. The resistor with the most current has a value of
What is the source voltage applied across a loop containing a resistor of 1000 ohm and capacitor of 15 microfarads in series when a current of 0.02 ampere flows across the circuit? Given that the voltage drop across capacitor is 5 Volts?